The engine holds about 4.7 quarts (roughly 4.5 liters) of engine oil for a standard drain-and-fill with a new filter.
For the 2018 Camry, which uses the 2.5-liter four-cylinder engine (A25A-FKS in most trims), the total oil needed to fill the engine from empty includes the filter. Actual oil required can vary slightly depending on the exact variant, local climate, and whether you replace the filter during the change. Here is how the numbers typically break down for routine maintenance.
Official guidance and typical practice
The following figures reflect common guidance for the 2.5 L engine found in the 2018 Camry. They’re useful for planning an oil change and ordering the right amount of oil.
- Oil capacity with filter: about 4.6–4.8 quarts (roughly 4.4–4.5 liters).
- Oil capacity without filter change: about 4.0–4.2 quarts (roughly 3.8–4.0 liters).
Note: Some service data and regional manuals list the capacity in a narrow band, such as 4.5 L (approximate) or 4.6 qt (with filter). Always verify with the dipstick after refilling to the proper level, as real-world results can vary slightly by oil type and engine condition.
Details and variants
Why numbers vary and how to use them
Exact capacity can differ by specific engine variant (the 2.5 L family in 2018 Camrys uses variants like the A25A-FKS), manufacturing tolerances, and the size of the oil filter installed at the factory or by a service center. For a standard oil change with a new filter, plan toward the higher end of the range and then top up as needed to reach the recommended dipstick range.
Practical tips for your oil change
When performing an oil change on a 2018 Camry 2.5 L, keep these guidelines in mind to avoid under- or overfilling the engine.
- Have an estimate ready: about 4.6–4.8 quarts (4.4–4.5 L) if you’re changing the filter.
- Always replace the oil filter during a full change; the oil capacity figures assume a new filter is installed.
- After adding oil, run the engine briefly, then recheck with the dipstick and top up to the correct level if needed.
Following these steps helps ensure proper lubrication, engine performance, and adherence to Toyota’s maintenance recommendations.
Summary
For the 2018 Toyota Camry with a 2.5 L engine, plan for roughly 4.6–4.8 quarts (about 4.4–4.5 liters) of engine oil when performing a full drain-and-fill with a new filter. If you’re draining and filling without replacing the filter, you’ll typically need about 4.0–4.2 quarts (3.8–4.0 liters). Always verify the oil level with the dipstick after the change to ensure the engine is at the correct mark.