The 2017 Nissan NV2500 with the 5.6-liter V8 engine requires about 7 quarts (6.6 liters) of engine oil for a full drain-and-fill, including a new oil filter. The exact amount can vary slightly by filter size and market, so always confirm with the owner's manual or dealer documentation.
Engine and capacity basics
The NV2500 is a heavy-duty cargo van, and in 2017 it used the VK56DE 5.6L V8 engine. Knowing the correct oil capacity helps with maintenance planning and oil-change intervals.
Key capacity figure
Typical service data lists the engine oil capacity for this configuration as approximately 7 quarts (6.6 liters) including the filter.
- Oil capacity including the filter: about 7 quarts (6.6 L).
Note: Capacity can vary slightly by market and filter size. For the precise figure for your VIN, refer to the official service data or the vehicle’s owner's manual.
Steps for an oil change (drain and fill)
To perform a standard drain-and-fill and reach the proper oil level, follow these steps. This list explains the typical process and what to expect during the procedure.
- Prepare the vehicle: warm engine to operating temperature, park on level ground, and gather supplies.
- Lift the vehicle and place a drain pan beneath the drain plug.
- Remove the drain plug and allow the old oil to drain completely.
- Remove and replace the oil filter with a new one.
- Reinstall the drain plug and pour in about 6.5 to 7 quarts of new oil (check manual; start with 6.5 qt and add to reach proper level).
- Run the engine for a minute, then turn it off and check the oil level with the dipstick, topping off as needed to reach the full mark.
- Recheck for leaks, reset the oil-change indicator if applicable, and dispose of used oil and filter responsibly.
The exact amount you add should bring the level to the full mark on the dipstick. If you’re close to the full line after the first attempt, run the engine and recheck, as some engines settle after restarting.
Notes and considerations
Always confirm oil type and capacity in your manual, as regional service data can vary and there may be advisories for specific variants or updated specs. If in doubt, contact a Nissan dealer or independent shop familiar with the NV family.
Summary
For a 2017 Nissan NV2500 with the 5.6L V8, plan for about 7 quarts (6.6 liters) of engine oil for a complete drain-and-fill, including a new filter. Use the vehicle’s dipstick to verify the level after refilling, and consult official documentation for your exact VIN and market.
How much oil does a 2017 Nissan 5.6 take?
6.9 quarts
The 5.6L V8 engine in your Titan requires 6.9 quarts, or 6.5 liters, of oil for optimal functioning. Note that the 6.5L figure refers to the Nissan Titan oil capacity necessary for each oil change, while the 5.6L measurement pertains to your engine's displacement.
How much oil does a Nissan NV2500 5.6 take?
approximately 7 quarts
Engine oil capacity is approximately 7 quarts.
What kind of oil does a Nissan NV 5.6 take?
2018-2021 Nissan NV3500 5.6L V8. Oil Type: Gasoline Engine Oil. Oil Composition: Fully Synthetic. SAE Oil Weight: 0W-20.
What kind of oil does a 2017 Nissan NV2500 take?
5W-30
Valvoline – High Mileage 5W-30 Full Synthetic Engine Oil, Prevents Leaks (Part No. 881169)