The 2017 Lincoln MKC 2.3L EcoBoost engine takes about 5.7 quarts (5.4 liters) of engine oil with a filter during a full drain-and-fill service.
For a broader understanding, this article explains the official capacity, recommended oil grade, and practical steps to perform an oil change on this model, using information aligned with Ford/Lincoln specifications and typical service practices.
Capacity specifics
Before listing the official figure, note that the capacity is defined for a standard oil change that includes replacing the oil filter. The MKC’s 2.3L EcoBoost engine uses this capacity across many Ford vehicles with the same engine family.
- 5.7 quarts (5.4 liters) with a new filter
Capacities can vary slightly depending on drain method and filter choice. Always verify the level with the dipstick after refilling and adjust as needed.
Oil grade and service guidelines
Recommended oil grade
Lincoln/Ford typically specifies fully synthetic engine oil in the range of 5W-20 for normal operating conditions on many EcoBoost engines. In hotter climates or with heavy loads, 5W-30 may be acceptable. Always follow the exact grade printed on the oil filler cap or in the owner's manual and use a manufacturer-approved synthetic oil such as Motorcraft.
Service approach and steps
When planning or performing an oil change, observe the following steps to ensure a proper refill and accurate level check.
- Warm the engine to operating temperature, then turn it off and let it sit for a few minutes to drain.
- Place the vehicle on a level surface and position a drain pan beneath the engine. Remove the drain plug and allow the old oil to drain completely.
- Remove the old oil filter, install a new one, and lubricate the gasket with a bit of new oil.
- Install the drain plug securely, then pour in the recommended amount of oil (about 5.7 quarts with filter). Use the dipstick to check the level and adjust as needed.
- Start the engine, run for a minute, then re-check the level and top up to the full mark if necessary. Dispose of used oil and the filter responsibly.
The above steps assume a standard drain and filter replacement; if your vehicle has a different oil capacity due to variant parts or a different filter, adjust accordingly.
Summary
The 2017 Lincoln MKC 2.3L EcoBoost requires approximately 5.7 quarts (5.4 liters) of engine oil for a full drain-and-fill with a filter. Use the recommended synthetic oil grade from the owner's manual and verify the level with the dipstick after refilling. Capacity can vary slightly depending on the drain and filter configuration.