In short, the 2.4-liter four-cylinder engine in the 2017 Honda Accord holds about 4.5 quarts (4.3 liters) of engine oil when changing the filter. After draining, add roughly 4.5 quarts and then check the level with the dipstick, topping up to the full mark as needed.
The question matters for anyone performing an oil change or planning maintenance on this model. The Accord’s capacity is modest, but getting the quantity right helps protect the engine and ensure accurate dipstick readings. This article lays out the official capacity, recommended oil grade, and practical steps for completing an oil change.
Capacity and oil type
Key capacity and oil-compatibility details for the 2.4L engine in the 2017 Accord:
- Engine oil capacity with filter: 4.5 quarts (4.3 liters).
- Recommended viscosity: generally 0W-20 (or 5W-20 in climates where 0W-20 is not specified); use an API SN/ILSAC GF-5 or newer full-synthetic or synthetic-blend oil.
- Note: The stated capacity assumes a new filter is installed; if the filter is not replaced, the precise fill amount may be slightly less, so always verify with the dipstick after pouring.
Understanding these specifications helps ensure you add the correct amount and maintain proper oil pressure and engine protection.
How to perform an oil change
When changing the oil on a 2017 Honda Accord with the 2.4L engine, preparation and correct steps help ensure a clean, safe process. Gather the necessary tools and follow a methodical routine.
- Warm up the engine for a few minutes to allow the oil to flow; this makes draining easier and more complete.
- Turn off the engine, engage the parking brake, and raise the front of the car if needed to access the drain plug.
- Place a drain pan underneath the oil pan and loosen the drain bolt to allow the old oil to drain completely.
- Remove and replace the oil filter with a new one; ensure the gasket is seated and lubricate the new filter seal with a bit of new oil.
- Install the drain bolt securely, then add the recommended amount of oil (about 4.5 quarts) through the oil fill cap.
- Replace the oil fill cap, start the engine, and run for 1-2 minutes; check for leaks, then turn off and let the engine settle before checking the dipstick.
- Check the oil level on the dipstick and top up as needed to reach the full mark; recheck after a few minutes of idle or driving.
For best results, dispose of old oil properly at a recycling facility and reset maintenance reminders per Honda’s guidelines.
Tips and cautions
Always confirm the exact specification in your owner's manual or a trusted service source, as engine variants or regional specs may affect the preferred oil viscosity and capacity.
Summary
The 2017 Honda Accord 2.4L generally requires about 4.5 quarts (4.3 liters) of engine oil with a new filter. Use 0W-20 (or 5W-20 where 0W-20 is not specified) that meets API SN or newer standards, and always verify fullness with the dipstick after a change. Following the correct steps ensures proper lubrication and engine longevity.