The 2017 Civic with a 2.0-liter engine typically requires about 4.3 quarts (roughly 4.1 liters) of engine oil when performing a full drain-and-fill with a new oil filter, using 0W-20 full synthetic oil. If the filter is not replaced, the total is closer to 4.0 quarts.
Understanding the spec and what it means for maintenance
The 2.0L i-VTEC engine used in the 2017 Civic is designed to run on Honda-recommended 0W-20 full-synthetic oil. The capacity figure commonly cited covers a complete oil change with a new filter; removing or skipping the filter change typically reduces the amount by a small margin. Always verify the actual level with the dipstick after adding oil, and adjust to the correct level as needed.
Capacity at a glance
Before you begin a drain-and-fill, here are the typical quantities to expect for the 2017 Civic 2.0L:
- With oil filter replacement (full drain and fill): approximately 4.3 quarts (4.1 L) of 0W-20 synthetic oil
- Without changing the filter: approximately 4.0 quarts (3.8 L)
Note that these figures assume you are using the factory-recommended oil grade and performing a standard drain-and-fill. Variations can occur due to differences in the exact trim, oil cooler arrangements, or if older seals affect the total capacity. Always finish with a proper dipstick check to confirm the correct level.
Practical tips for proper oil servicing
For best performance and protection, use Honda-approved 0W-20 full-synthetic oil and replace the oil filter during every oil change. Routine oil-change intervals for the Honda Civic typically range from 5,000 to 7,500 miles (or as indicated by the vehicle’s maintenance minder) depending on driving conditions and oil grade. If you drive under severe conditions, consider more frequent changes.
Summary
In short, a 2017 Honda Civic with a 2.0L engine generally takes about 4.3 quarts (4.1 liters) of 0W-20 oil when you perform a full drain and fill with a new filter. If you skip the filter replacement, expect around 4.0 quarts. Always confirm the level with the dipstick after adding oil and follow the owner’s manual recommendations for oil type and change intervals.