The 2016 Ford F-150 with the 3.5L EcoBoost engine takes about 6 quarts (roughly 5.7 liters) of engine oil for a full oil change that includes a new oil filter, using Ford-recommended 5W-20 synthetic oil.
Oil capacity and what it includes
The capacity figure refers to the total amount of oil needed when performing a standard oil change with a new filter installed. For the 3.5 EcoBoost in the 2016 F-150, this is 6 quarts (5.7 liters). This ensures proper lubrication after the filter is replaced and the old oil is drained.
What the capacity covers
This 6-quart specification assumes you are draining the old oil completely and replacing the oil filter. If you change only the oil without replacing the filter, the amount added may be slightly less, but the standard service typically follows the 6-quart guideline with a new filter.
Oil type and maintenance guidelines
Use 5W-20 full synthetic oil for the 3.5 EcoBoost. For maintenance intervals, Ford commonly recommends about 7,500 miles (roughly 12,000 kilometers) under normal driving conditions, with more frequent changes under severe driving conditions. Always refer to your vehicle’s owner's manual or Ford’s official service guidance for the exact schedule for your specific vehicle configuration and region.
Choosing the right oil and when to change
Stick to 5W-20 unless your manual specifies an alternative for extreme temperatures. Follow Ford’s maintenance guide for oil-change intervals and use a quality oil filter to maintain optimal engine protection.
Practical tips for checking and refilling
Before refilling, run the engine briefly and then park on level ground. After draining and replacing the filter, add oil gradually and recheck with the dipstick to avoid overfilling. Allow the oil to settle, then perform a final dipstick check and start the engine to ensure proper circulation and oil pressure.
Summary
For a 2016 Ford F-150 with the 3.5 EcoBoost, the total oil capacity for a standard oil-and-filter change is about 6 quarts (5.7 liters), using 5W-20 full synthetic oil. Always follow the owner's manual for the exact maintenance intervals and use the correct filter and oil specification for your vehicle.
Can I use 5W30 instead of 5W20 in my Ford F-150?
When you drive a Ford F-150 with a 5.0L V8 engine, your Ford F-150 oil type is SAE 5W-20 or SAE 5W-30 motor oil. Pair that with an OEM Ford F-150 oil filter, and you're good to go on Hudson and Port Richey streets.
What happens if you overfill 3.5 EcoBoost oil?
Aeration and Foaming
Overfilled engine oil may become aerated as the crankshaft stirs it into foam. This reduces the oil's ability to lubricate and cool critical engine components, accelerating wear, and potentially causing engine problems.
How much oil does a 2016 F-150 3.5 EcoBoost engine take?
3.5L V6 Engine: 6 quarts.
What's the best oil to use in a 3.5 EcoBoost?
5W-30
Ford's recommended oil types now vary more widely based on powertrain: 2.7L & 3.5L EcoBoost: 5W-30 Full Synthetic.