For the 2015 Dodge Dart, oil capacity depends on which engine you have. The 2.4-liter Tigershark engine requires about 5 quarts (approximately 4.7 liters) of oil with a filter, while the 1.4-liter MultiAir Turbo engine needs roughly 4.5 quarts (about 4.3 liters) with a filter. Always verify with the owner’s manual and check the dipstick to ensure the level is correct after a fill.
Engine options and oil capacity
The Dodge Dart line for 2015 offered two common four-cylinder engines. Capacities listed here reflect typical production specifications; always confirm with your VIN and manual.
- 2.4L Tigershark I4 — oil capacity: 5 quarts (≈4.7 L) with filter
- 1.4L MultiAir Turbo I4 — oil capacity: 4.5 quarts (≈4.3 L) with filter
When you perform an oil change, ensure you replace the filter and use the correct oil specification as recommended by Chrysler/ Fiat and the vehicle’s manual.
Oil type and maintenance intervals
Oil type and service intervals vary by engine and climate, so the official guidance in the owner’s manual should take precedence. In general, modern Mopar engines in the Dart line use synthetic or full-synthetic blends and have maintenance schedules that reflect environmental conditions and driving habits.
Choosing the right oil grade
Most 2015 Dart engines are configured to use at least a synthetic 5W-20 oil, with some climates or specifications allowing 5W-30. Always follow the grade specified in the owner's manual for your particular engine and region.
Maintenance intervals
Maintenance intervals depend on engine type and driving conditions. Follow the schedule printed in the owner's manual and, if equipped, the vehicle’s oil life monitoring system. In general, synthetic oils often extend intervals compared with conventional oils, but exact miles/time should come from the official schedule for your Dart’s engine.
How to check and refill the oil
To ensure you maintain proper oil levels and engine health, follow these steps carefully.
- Park on a level surface and turn off the engine. Wait several minutes for oil to settle.
- Open the hood and locate the oil dipstick; pull it out, wipe clean, reinsert fully, then pull it again to check the level.
- If the level is low, add oil gradually in small amounts (about a quarter to half a quart at a time), recheck with the dipstick, and avoid overfilling.
- Replace the dipstick, close the hood, and start the engine briefly to circulate the oil, then recheck the level again when the engine is off.
- Check for leaks around the drain plug and oil filter after the refill and dispose of used oil according to local regulations.
When in doubt, consult the owner's manual or a qualified technician to ensure the correct quantity and grade for your specific Dart engine.
Summary
The 2015 Dodge Dart uses two main four-cylinder engines with different oil capacities: about 5 quarts for the 2.4L Tigershark and about 4.5 quarts for the 1.4L Turbo, both with a standard oil filter. Always confirm the exact specification for your VIN, use the recommended oil grade, and follow the maintenance schedule in the manual. Regularly checking and correctly refilling oil helps protect the engine and extend its life.