The 2014 Ford E-350 with the 6.8-liter V10 engine uses about 6 quarts of engine oil when performing a full oil change with a new filter.
In practical terms, the total oil capacity is around 6 quarts (approximately 5.7 liters). Use the recommended viscosity—typically 5W-20 for most conditions, or 5W-30 in hotter climates or as directed by the owner's manual—to ensure proper lubrication and cold-start protection.
Oil capacity and viscosity: essential figures
Here are the essential figures and recommendations for the oil capacity and viscosity of the 6.8L V10 E-350.
- Oil capacity with a new filter: 6 quarts (5.7 liters).
- Recommended oil viscosity: 5W-20 for most driving; 5W-30 in hotter climates or as specified by the owner's manual.
- Note: Always replace the oil filter when changing the oil to maintain proper filtration and capacity.
Keeping to these figures helps ensure proper lubrication, optimal engine performance, and easier future maintenance.
DIY oil change steps for the 6.8L V10 E-350
If you plan to do the change yourself, follow these practical steps to avoid common mistakes.
- With the engine warm, safely raise the van and support it on stands or a hoist.
- Place a drain pan beneath the engine and remove the oil drain plug to drain the old oil completely.
- Remove the old oil filter and install a new filter, lubricating the gasket with a bit of fresh oil.
- Install the drain plug and pour in 5 quarts of new oil using a funnel.
- Start the engine and let it run for about a minute, then turn it off and wait 5–10 minutes for the oil to settle.
- Check the oil level with the dipstick and add more oil as needed to reach the full mark, taking care not to overfill.
- Dispose of the used oil and filter responsibly and reset any oil-change indicator if equipped.
Always ensure proper oil level and use approved containers to store or dispose of used oil.
Summary
For the 2014 Ford E-350 with the 6.8L V10, plan on about 6 quarts of engine oil with a new filter for a standard change. The typical viscosity guidance is 5W-20, or 5W-30 in hotter conditions as specified by the manual. Follow the step-by-step process above to perform a proper oil change, and always verify the final oil level on the dipstick after a short engine run.