The Crosstour’s 3.5-liter V6 requires about 5.5 quarts of engine oil with a new filter.
In this context, the 2012 Crosstour uses a 3.5-liter V6 and the official capacity refers to a full oil change with the filter installed. The recommended oil viscosity for most climates is 0W-20 synthetic oil, though 5W-20 can be acceptable in warmer conditions or as specified in the owner's manual. Always consult your manual or a Honda service professional for location-specific guidance and VIN-based requirements.
Oil capacity and specifications
Here are the key figures and recommendations you should know before changing the oil on a 2012 Crosstour 3.5:
- Capacity: 5.5 quarts (approximately 5.2 liters) of engine oil with a new filter.
- Viscosity: 0W-20 is commonly recommended for this engine; 5W-20 may be acceptable in some climates per the owner's manual.
- Oil type: Full-synthetic oil is typically preferred for best protection and performance on this engine.
- Verification: After filling, run the engine to operating temperature, recheck the level with the dipstick, and top up if needed to reach the full mark.
For accurate guidance tailored to your exact vehicle, consult the owner’s manual or a Honda dealer, especially if you have a different drivetrain configuration (such as all-wheel drive) or regional climate considerations.
Oil change quick checklist
If you’re planning to perform an oil change yourself, use this concise procedure as a guide. It’s intended to be a general reference and not a substitute for the official service manual.
- Gather supplies: the correct oil (5.5 quarts of 0W-20 synthetic for most cars), a new oil filter, a drain pan, a wrench for the drain plug, and a funnel.
- Warm up the engine briefly, then turn it off and let it rest a few minutes so the oil can settle.
- Place the drain pan beneath the oil pan and remove the drain plug to let used oil drain completely.
- Remove the old oil filter, ensuring the mounting surface is clean; install a new filter and lubricate the gasket with a bit of new oil.
- Reinstall the drain plug securely, then refill with 5.5 quarts of the recommended oil using a funnel.
- Start the engine, run for a minute, then turn off and check for leaks; wait a few minutes and recheck the oil level with the dipstick, adding oil as necessary to reach the full mark.
If you’re not comfortable performing an oil change yourself, have a qualified technician handle it to ensure proper drainage, filter seating, and oil level.
Summary
The 2012 Honda Crosstour with the 3.5L V6 generally takes about 5.5 quarts of engine oil (roughly 5.2 liters) when you do a full change with a new filter. Use a 0W-20 synthetic oil as the baseline recommendation, with 5W-20 as an alternative in certain climates per the owner’s manual. Always verify exact specs for your vehicle and follow a careful oil-change procedure or consult a professional if in doubt.