The oil drain plug on a 2018 Honda Accord uses a 14mm hex head with M14x1.5 thread.
For the 2018 Accord, which offered both a 1.5-liter turbocharged engine and a 2.0-liter turbocharged engine, the drain plug sizing is the same. Always verify with your owner's manual or a Honda service bulletin for your exact VIN, since there can be small variations in washers or installation requirements.
Technical specifications
Key measurements you should know before removing the drain plug:
- Thread size: M14x1.5
- Head size: 14mm hex (socket or wrench)
- Sealing washer: may be used or replaced depending on service history
- Engines covered: 1.5L turbo and 2.0L turbo in the 2018 Accord
These specifications generally apply to both engine variants in the 2018 Accord. Always confirm for your specific VIN with the owner's manual or service information.
Oil-change considerations
Tools and preparation
To perform an oil change, you’ll typically need a 14mm socket or wrench, a replacement sealing washer if required, an oil catch pan, and fresh oil as recommended by Honda for your engine.
Using the correct tools and parts helps prevent cross-threading, leaks, and damaged threads during the drain and refill process.
Reinstallation and safety tips
When reassembling, avoid overtightening the drain plug and ensure any washer is properly seated. Follow the manufacturer’s torque specification to maintain a proper seal and prevent leaks; consult the owner's manual for the exact value applicable to your VIN.
Summary
In short, the 2018 Honda Accord uses a drain plug with a 14mm hex head and M14x1.5 thread, common to both the 1.5L and 2.0L turbo engines. Verify exact washer requirements and torque values for your vehicle in the owner's manual or service bulletin to ensure a leak-free oil change.
What size socket for Honda Accord drain plug?
EASY TO INSTALL - Our plug will install in place of your current drain plug. It will arrive with an aluminum crush washer, which is recommended to be replaced with every oil change. USES A 17MM WRENCH.
What size socket do I need to remove a drain plug?
What size wrench do I need for my oil drain plug? The most common sizes are 14 mm, 15 mm, and 17 mm hex. Some vehicles use a 3/8-inch square drive or an internal Allen key (8 mm or larger). Check your owner's manual or measure the plug directly.
Are all oil drain plugs 14mm?
Most cars use oil drain plugs between 13mm and 17mm, depending on the brand. For example, Toyota and Honda typically use 14mm or 17mm, while Ford often uses 13mm or 15mm. Using a universal drain plug socket set like the BILITOOLS 23-Piece Kit ensures you always have the right size on hand.
What size is the oil drain plug on a 2018 Honda Accord?
17 mm
Dorman – Standard Engine Oil Drain Plug: M14-1.50 Thread, 17 mm Head, 1 Clamshell/Card (Part No.