The 2007 Honda Accord with a 2.4-liter four-cylinder engine typically requires about 4.5 quarts of oil with a new filter (roughly 4.3 liters). Without the filter, expect about 4.1 quarts (3.9 liters).
In practice, use this as a guide and verify the level with the dipstick after filling. This article breaks down the official capacities, recommended oil types, and practical steps for a proper oil change on this model.
Oil capacity for the 2.4 L engine
The following figures distinguish whether a filter change is included. They are the standard references used by most owners and technicians for the 2007 Accord's 2.4 L engine.
- With oil filter: 4.5 quarts (4.3 liters)
- Without oil filter: 4.1 quarts (3.9 liters)
When refilling, begin with the higher figure and adjust after checking the dipstick to reach the proper level.
Recommended oil grade and type
For most climates, Honda specifies a viscosity of 5W-20 for the 2.4 L engine. In hotter environments or for certain driving conditions, 5W-30 may be acceptable. Use oil that meets API service SN (or newer) and consider Honda Genuine Motor Oil or equivalent that meets Honda’s specifications.
- Viscosity: 5W-20 (recommended in standard conditions)
- Alternative: 5W-30 in hot climates or under specific conditions
- Oil specification: API SN or newer; Honda-approved or equivalent
Always check the vehicle’s manual for the exact specification tied to your VIN and local climate, and replace the oil filter with each change.
Step-by-step oil change (summary)
Here is a concise sequence to guide you through an oil change on the 2007 Accord 2.4 L. These steps assume you have the right tools and a safe working environment.
- Warm up the engine briefly, turn off, and set the parking brake. Gather the oil, filter, wrench, and a drain pan.
- Raise the car safely and place it on jack stands if you’re not using a ramp. Position the pan beneath the drain plug.
- Remove the drain plug, and let the old oil drain completely while you prepare a new filter.
- Remove the old oil filter, install the new filter by hand until it’s snug, and then give it a half-turn per the filter’s instructions.
- Reinstall the drain plug with a new washer, wipe up any spills, and pour in the recommended oil. Start with the full-capacity amount above, then gradually add more as needed.
- Check the oil level with the dipstick, ensure it’s within the marked range, and replace the dipstick and oil cap securely.
- Run the engine for a few minutes, check for leaks, turn off, recheck the level, and top up if necessary. Dispose of used oil responsibly.
Following these steps carefully helps ensure a clean engine and proper oil level after the change.
Summary
The 2007 Honda Accord 2.4 L takes about 4.5 quarts of oil with a filter, or about 4.1 quarts without one. Use 5W-20 oil in most cases, with 5W-30 as an option in hot climates, and choose oil that meets API SN or newer. Always verify the final level with the dipstick after filling, and perform regular oil changes using a clean filter and proper disposal of used oil.