For a 2008 Honda Accord, the amount of oil you need depends on the engine. The four‑cylinder 2.4L uses about 4.4–4.5 quarts (roughly 4.2–4.3 L) with the filter, while the 3.0L V6 requires about 5.0–5.5 quarts (roughly 4.7–5.2 L) with the filter. Always verify the exact capacity in your owner’s manual or on the under-hood oil-cap sticker.
Engine options and official oil capacities
The 2008 Accord was offered with two engines: a 2.4-liter inline‑4 and a 3.0-liter V6. Oil capacity varies slightly depending on whether the oil filter is replaced during the change. The following figures are typical baselines for a standard oil change with a new filter:
Note: Capacities can vary by market and filter size, so confirm with your manual or the vehicle’s under-hood sticker.
- 2.4 L inline-4: approximately 4.4–4.5 quarts (about 4.2–4.3 L) with filter
- 3.0 L V6: approximately 5.0–5.5 quarts (about 4.7–5.2 L) with filter
These values serve as practical starting points. If your vehicle uses a different oil filter or if the manual specifies a slightly different figure, follow that guidance.
Choosing the right oil and how to fill
Use the viscosity recommended by Honda for your engine and climate (commonly 5W-20 or 5W-30). Always use a high-quality oil that meets Honda’s specs and replace the oil filter during a full change. When refilling, add oil in small increments and check the level with the dipstick to avoid overfill.
- Park on level ground and turn off the engine. If recently driven, allow the engine to cool for about 10 minutes before checking or draining oil.
- Remove and wipe the dipstick, reinsert, and pull it out to check the current oil level.
- Pour in oil gradually in small amounts (about 1/2 quart at a time), then wait a moment for the oil to settle and recheck the dipstick.
- Continue adding until the dipstick shows the level near the full mark on a level surface.
- Clean up any spills and replace the oil cap. Start the engine and check for leaks after a few minutes of running.
Proper disposal of used oil is essential. Take it to an authorized recycling facility or auto shop that accepts used oil.
Additional tips and reminders
Always refer to the owner’s manual for the exact specification and capacity for your specific vehicle. The 2008 Accord’s two engine options span a small capacity range, but the manual will provide the definitive figure, including whether you’re performing a standard change or a more involved service that might alter the total oil amount.
In summary, the 2008 Honda Accord uses roughly 4.4–4.5 quarts of oil for the four-cylinder version and about 5.0–5.5 quarts for the V6 version, with the exact amount depending on filter changes and market specifications. Verify with the official manual and fill carefully using the recommended oil grade.
Summary
Oil capacity for a 2008 Honda Accord varies by engine: about 4.4–4.5 quarts for the 2.4L four-cylinder and about 5.0–5.5 quarts for the 3.0L V6, including the new filter. Always confirm the exact figure in your owner’s manual or on the hood sticker, use the recommended oil grade, and fill gradually while rechecking with the dipstick to avoid overfilling.