For a 2010 Silverado, replacing a single front wheel bearing hub assembly typically runs about $300–$600, with both front wheels costing roughly $600–$1,150. Rear-wheel bearings per axle usually fall in the $400–$900 range. Final quotes depend on local labor rates, part choices, and whether additional work such as brake service or ABS sensor replacement is needed.
What drives the price
Wheel bearing replacement combines the cost of parts, labor, and any related hardware. On many Silverado models, the front bearing is replaced as a hub assembly that includes the bearing and often an ABS sensor, which simplifies installation but can raise parts costs. Rear bearings are typically pressed into the axle housing and may require more labor. Location, shop type, and whether you replace just one wheel or both can all significantly influence the total.
Typical cost ranges
The estimates below reflect common market pricing in the United States for a single wheel and for common configurations on a 2010 Silverado. They assume standard labor rates and typical parts.
Before listing the ranges, note that actual quotes depend on your vehicle’s exact configuration, the presence of an ABS sensor, rotor condition, and whether any brake components are replaced at the same time.
- Front-wheel hub replacement (one wheel): 300–600 USD
- Front-wheel hub replacement (both wheels on the same axle): 600–1,150 USD
- Rear-wheel bearing replacement (per axle): 400–900 USD
Prices vary by region and shop. Always obtain a written estimate that itemizes parts and labor before authorizing work.
Other considerations
Several factors can push the price higher or lower. If brakes are worn, rotors or pads may need replacement, adding to the bill. ABS sensor wiring, diagnostic time, and the need to press bearings or clean/repair hub components can also affect labor. Some shops offer bundled pricing or use aftermarket parts at a lower cost, while dealers may charge more but provide OEM parts and dealer-specific warranties.
Tips for getting a reliable quote
Ask for a written estimate that breaks out parts and labor per wheel, confirm whether aftermarket or OEM parts are used, and inquire about any core charges or additional fees. If possible, request a separate line item for any brake work and a note on whether alignment is recommended after the repair.
Summary: Replacing wheel bearings on a 2010 Chevy Silverado typically costs about $300–$600 per front wheel, $400–$900 per rear axle, and about $600–$1,150 if you replace both front hubs. Location, parts choice, and any added services can shift the final price.
Bottom line: If you’re hearing grinding or humming and suspect worn wheel bearings, contact a few local shops for written estimates to compare parts, labor, and potential add-ons before proceeding.