Typically, replacing the oil pressure sensor on a 2015 Ford Explorer costs about $120 to $210 in total, depending on parts choice and local labor rates. In some cases, especially if extra diagnostics or services are needed, the bill can rise toward $300.
The price covers the sensor itself and the labor to remove the old sensor and install the new one, plus a quick verification of oil pressure and warning-light status. Costs vary by engine variant, sensor quality (OEM vs aftermarket), and regional labor rates. This article breaks down typical costs, factors that influence them, and what to expect during replacement.
Cost snapshot
The following ranges reflect common price points in the United States and Canada for the oil pressure sensor replacement on a 2015 Ford Explorer. Actual prices may vary by location and shop.
- Parts: OEM sensor typically $45–$70; aftermarket sensors commonly $20–$60. More specialized or dealer-only units can cost more.
- Labor: Replacing the sensor usually takes 0.5–1.5 hours, depending on engine layout and accessibility; standard shop rates run about $100–$150 per hour, giving roughly $50–$225 in labor.
- Additional costs: Diagnostic fees if a failure isn’t already diagnosed, sales tax, shop fees, and any necessary oil or gasket costs if oil is drained during the job.
In practice, most Explorer owners see a total bill in the $120–$210 range for this repair, with higher totals if dealer-level service, extensive diagnostics, or premium parts are chosen.
What to expect during replacement
Here is a typical sequence technicians follow to replace the oil pressure sensor, along with the approximate time each step takes. Exact steps can vary by engine type and vehicle configuration.
- Disconnect the negative battery terminal to prevent electrical shorts.
- Locate the oil pressure sensor on the engine block or near the oil filter; refer to the 2015 Explorer’s service manual for the exact location on your engine variant.
- Disconnect the electrical connector from the sensor.
- Remove the old sensor with the proper wrench or socket; expect a small amount of oil to drain.
- Install the new sensor, apply any required thread sealant or gasket per manufacturer instructions, and tighten to the specified torque.
- Reconnect the electrical connector and reattach the battery if disconnected; top off or check oil level if oil was drained.
- Start the engine, check for leaks, and verify that the oil pressure reading and warning light function correctly; reset warnings if applicable.
The replacement is typically a straightforward job for many shops and can complete in roughly 0.5–2 hours, depending on access and whether additional services are performed.
Summary
For a 2015 Ford Explorer, the oil pressure sensor replacement usually costs about $120–$210 in total, with OEM sensors costing more than aftermarket ones. Labor time is typically 0.5–1.5 hours at standard shop rates, and diagnostic or oil-services add-ons can affect the final price. Get a clear written estimate that breaks out parts, labor, and diagnostics, and consider confirming the sensor type (OEM vs aftermarket) before work begins.