What goes into the price
The total cost for replacing a wheel bearing on a 2013 CR-V is driven by parts, labor, and any follow-on services. Below is a breakdown of the main factors that affect the final bill.
Front-wheel-drive vs all-wheel-drive configurations
Most 2013 CR-V models are sold as front-wheel drive, with the front wheel bearing/hub assembly being the most common replacement. All-wheel-drive versions may incur different rear bearing service costs due to the independent rear suspension setup and potential complexity. The price reflects both part type and labor time.
Pricing components typically include:
- Parts: hub bearing assembly (front or rear). OEM hub assemblies for the CR-V generally range from about 200 to 350 USD per wheel; aftermarket options can be cheaper, typically 50 to 150 USD.
- Labor: replacing a hub assembly usually takes 1.5 to 2.5 hours per wheel at a shop rate of roughly 75 to 125 USD per hour, depending on region and shop.
- Additional costs: brake rotor resurfacing or replacement if needed, ABS sensor considerations, wheel alignment after replacement, and potential tire or brake component inspection.
Conclusion: In most cases, expect a per-wheel total of about 250 to 600 USD, with higher costs if you’re dealing with AWD, rear bearings, or require an alignment.
Cost scenarios for the 2013 Honda CR-V
To give you a clearer picture, here are typical price ranges based on common situations.
- Single-front-wheel bearing replacement on a CR-V (typically FWD): approximately 250 to 600 USD.
- Single-rear-wheel bearing replacement (less common, depends on trim and setup): approximately 300 to 700 USD.
- Both front wheels replaced on a CR-V: roughly 500 to 1,200 USD.
- All four bearings replaced (rare, full bearing hub overhaul): 1,000 to 2,000 USD, depending on parts and labor.
Note: Prices can vary by region, repair shop, whether OEM or aftermarket parts are used, and whether an alignment is included or required after the work.
Ways to save and what to check before you approve the job
Before authorizing the work, consider these tips to avoid surprises and ensure you’re getting a fair deal.
- Get multiple written estimates from reputable shops and confirm whether they quote hub assemblies or bearings only.
- Ask if the price includes an alignment and whether ABS sensors are included if needed.
- Consider aftermarket hub assemblies if you’re price-sensitive, but ensure compatibility with ABS and wheel-speed sensors.
- Ensure the replacement is performed by a qualified technician; improper installation can lead to vibration, braking issues, or sensor faults.
Conclusion: By shopping around and asking targeted questions, you can secure a reliable price that covers all necessary components and services.
Summary
The cost to replace a wheel bearing on a 2013 Honda CR-V typically falls in the 250 to 600 USD per wheel range, with 500 to 1,200 USD for replacing both front wheels and higher costs if rear bearings or AWD are involved. Regional differences, parts choices, and whether an alignment is needed all influence the final bill. Plan ahead by getting quotes that break down parts, labor, and any add-ons.