Replacing a wheel bearing on a 2009 Honda Civic typically costs about $300 to $600 per front wheel and $250 to $500 per rear wheel, including parts and labor. Prices vary by region, whether you choose OEM or aftermarket parts, and whether the job requires a full hub assembly or a bearing. Labor rates commonly range from about $75 to $125 per hour, and the work often takes 1 to 3 hours per wheel depending on conditions.
What affects the price
Several factors influence how much you’ll pay for wheel bearing replacement on a Civic. The following items commonly affect totals across shops and regions:
- Front vs rear location and the corresponding part type (hub assembly versus bearing alone)
- Quality and type of part (OEM vs aftermarket; hub assemblies are often sold as complete units)
- Labor rate in your area and the shop’s diagnostic time
- Need for additional parts or services (axle nut, ABS sensor, brakes, or rotor replacement)
- Vehicle condition (rusted fasteners or seized components can extend labor time)
Understanding these factors helps you compare quotes more accurately and avoid surprise charges after the initial estimate.
Estimated cost ranges by wheel position
Front-wheel bearing/hub assembly replacement
Front-wheel bearings on the Civic are typically serviced as hub assemblies. This position tends to be the more expensive of the two due to part complexity and access.
- Typical total per wheel: 300–600
- Parts component: 100–350 (varies by OEM vs aftermarket and whether a full hub is used)
- Labor: 150–350 (plus any diagnostic time)
In higher-cost metropolitan areas or for OEM hub assemblies, the price can creep toward the upper end of the range or slightly higher if additional parts are required.
Rear-wheel bearing replacement
Rear bearings on a 2009 Civic are generally less expensive than the front, but can still involve replacing a hub assembly depending on the design. Labor times are typically shorter, contributing to lower overall cost.
- Typical total per wheel: 250–500
- Parts component: 60–250 (often similar to the front, but sometimes cheaper for rear)
- Labor: 120–300
Rear repairs can be especially cost-effective when aftermarket hubs are used or when the bearing is available as a simpler unit rather than a full hub assembly.
Other considerations and money-saving tips
To avoid surprises, consider these practical tips when planning a wheel bearing replacement on a 2009 Civic:
- Ask for an itemized quote that separates parts, labor, and any additional services (alignment, rotor/brake service, ABS sensor work).
- Inquire whether the shop recommends OEM or aftermarket parts and what warranties apply.
- Check if wheel alignment is recommended after a hub/bearing replacement, especially if other suspension work was performed.
- Shop around and compare multiple estimates, but beware unusually low quotes that may indicate subpar parts or insufficient labor time.
Choosing a reputable shop with clear pricing can help you avoid upcharges and ensure the job is done correctly the first time.
Summary
For a 2009 Honda Civic, expect roughly $300–$600 per front wheel and $250–$500 per rear wheel for wheel bearing replacement, including parts and labor. Regional differences, part quality, and whether a hub assembly is required or pressed-in bearings can shift prices. Always request a detailed estimate, confirm whether alignment is needed, and verify the warranty on parts and labor to ensure you get fair value for the repair.