A typical front-wheel bearing hub replacement for a 2008 Honda Civic runs about $300–$600 per wheel, while rear bearing work is usually in the $200–$450 range per wheel. Prices vary by region, shop, and whether you replace just the bearing or the full hub assembly.
What affects the price
Several factors influence the final bill when replacing a wheel bearing on a 2008 Civic. The car's configuration, the shop's rate, and the parts chosen all play a role.
- Front versus rear replacement (front work is more common and often costs more due to hub assemblies).
- Hub assembly versus bearing-only replacement (Civics of this era typically use a hub assembly with an integrated bearing).
- OEM versus aftermarket parts (OEM parts generally cost more but may carry factory warranties).
- Labor rate and location (urban areas and dealers tend to charge more).
- Additional repairs that may be required (brake components, ABS sensor, rotor resurfacing, or wheel alignment).
- Vehicle condition (rust, corrosion, or seized components can extend service time).
Prices can vary widely, so it’s wise to get written quotes that break out parts and labor and to confirm what is included in the price.
Typical cost ranges by scenario
Below are common ranges you can expect for a 2008 Civic, noting that front hub replacement is the most common scenario and prices vary by shop and region.
- Front hub assembly replacement (most common on this Civic generation): Parts roughly $120–$350; labor about $120–$300; total per wheel typically $240–$650.
- Front bearing only (rare for this model but possible when the bearing races can be pressed separately): Parts roughly $60–$150; labor about $120–$250; total $180–$400.
- Rear hub assembly replacement: Parts roughly $100–$300; labor about $100–$250; total per wheel typically $200–$550.
- Rear bearing only: Parts roughly $60–$120; labor about $100–$230; total $160–$350.
Note: Dealers tend to price toward the higher end of these ranges, while independent shops often offer lower rates, especially with aftermarket parts. Always confirm what’s included (nut, sensors, brake components, and taxes) in the quote.
What to expect at the shop
Here is a typical sequence the technician follows when replacing a wheel bearing hub on a Civic. The process can vary slightly by shop and whether ABS sensors are involved.
- Diagnosis and confirmation of the faulty bearing or hub.
- Vehicle is raised and the wheel is removed.
- Caliper and brake components are moved aside; the hub is accessed.
- Wheel speed sensor/ABS wiring is disconnected if present.
- Old hub bearing assembly is removed and replaced with the new unit.
- ABS sensor and wheel components are reconnected; brakes are reassembled.
- Vehicle is lowered, brakes are tested, and a road test ensures proper operation.
- Shop may suggest a brake inspection and wheel alignment if needed.
In practice, expect a completion time of around one to three hours, depending on whether the job is straightforward or hindered by corrosion or sensor issues.
Summary
Replacing a wheel bearing on a 2008 Honda Civic is a common repair with price ranges that depend on front versus rear work, hub assembly versus bearing-only replacement, and the shop’s labor rate. Expect roughly $240–$650 per front wheel and $200–$550 per rear wheel, before taxes and fees. Always obtain multiple quotes, verify inclusions, and watch for additional costs such as brake component repairs or wheel alignment. With careful shop selection, you can ensure the repair is done correctly and at a fair price.