The typical installed brake job for a 2013 Dodge Avenger runs roughly from $300 to $900, depending on parts and whether rotors are replaced. Pads-only work is cheaper, while replacing pads and rotors increases the price.
Brake prices vary by location, part quality, and whether you’re servicing the front or rear brakes. Below is a detailed look at what drives cost and what you can expect to pay today.
What drives the price of brakes on a 2013 Dodge Avenger
Several factors determine the final bill, including part selections, whether rotors are replaced, and labor charges. Here are the typical components involved and their general price ranges.
- Front brake pads (set): 40–120
- Front brake rotors (each): 30–90
- Rear brake pads (set): 25–100
- Rear brake rotors (each): 25–85
- Calipers (if replacement is needed): 100–350 each
- Hardware/sensors (if equipped): 5–40
- Labor rate (typical shop): 70–120 per hour
- Estimated labor time: 1–2 hours per axle for pads only; 2–3+ hours per axle for pads plus rotors
These ranges reflect common aftermarket versus OEM part choices and typical regional differences. If your car has unusual wear, seized calipers, or ABS-related issues, costs can run higher.
Installed price ranges by scenario
To give you a practical sense of total costs, here are rough installed-price ranges for common brake-repair scenarios on a 2013 Avenger. Actual prices will vary by location and shop.
- Front brakes (pads only, per axle): 150–300
- Front brakes (pads + rotors, per axle): 320–550
- Rear brakes (pads only, per axle): 120–250
- Rear brakes (pads + rotors, per axle): 240–450
- All four wheels (pads + rotors): 500–900
Note: If one or both sides require caliper replacement or if a shop uses OEM parts, the upper end of these ranges can rise. Conversely, opting for aftermarket parts and rotor resurfacing where approved can lower costs.
Ways to save money
Shopping smart and planning ahead can help keep brake costs reasonable without compromising safety.
Practical tips
- Get quotes from several shops to compare price and included services (labor, fluids, disposal fees).
- Ask about aftermarket (non-OEM) parts versus OEM; many shops offer economy options with solid performance.
- Ask whether rotors can be resurfaced instead of replaced if they’re within spec and not deeply scored.
- Ensure you’re not paying for unnecessary parts (e.g., calipers replaced on a non-seizing system).
- Look for package deals where pads, rotors, and labor are bundled at a discount.
- Check for coupons or promotions from local service centers or national chains.
Planning ahead and understanding what each component costs can help you decide the most cost-effective approach for your Avenger.
Summary
For a 2013 Dodge Avenger, brake service costs vary widely based on parts and labor. A pads-only job is the least expensive route, while replacing pads and rotors on both axles can approach the upper end of the range. Expect installed totals roughly from $300 to $900, with regional differences and choices between aftermarket and OEM parts driving the spread. Always compare multiple quotes and confirm what’s included in the price to avoid surprises.