In short, front brake pads for a 2010 Honda CR-V typically run about $40 to $90 per axle, while rear pads run roughly $25 to $60 per axle. Labor to install them at a shop is extra and varies by location.
Brake pad prices depend on position (front vs rear), material (organic/semi-metallic vs ceramic), brand, and where you buy them. For a 2010 CR-V, you’ll most often replace front pads, and you’ll need to verify whether the rear brakes use rotors or drums, as that changes the part you buy (pads vs shoes) and the price.
Front brake pads: price ranges
Below are typical price ranges you’ll see for front brake pad sets by material when shopping online or at auto parts stores.
- Non-ceramic (organic or semi-metallic): generally about $30–$60 per axle (two pads per wheel, four pads total per axle).
- Ceramic: typically $60–$110 per axle.
Material choice and performance
Material choice affects wear, noise, and dust. Ceramic pads tend to be quieter and produce less brake dust but cost more upfront, while non-ceramic pads are cheaper but may wear faster and dust more.
Front brake pads are the most commonly replaced part during routine maintenance, and the price spectrum reflects performance and noise characteristics. Ceramic pads tend to be quieter and produce less dust but cost more.
Rear brakes: discs or drums — price ranges
Some 2010 CR-Vs use rear brake configurations that are not simply "pads" — some trims or configurations use rear drum brakes with shoes, which are priced differently. If your rear brakes are discs, the prices below apply; if they are drums, you’ll be replacing shoes instead of pads and costs vary.
- Rear disc brakes (pads): Non-ceramic: about $25–$60 per axle; Ceramic: about $50–$90 per axle.
- Rear drum brakes with shoes (not pads): shoes and hardware typically $20–$60 per axle; some kits include hardware and wheel cylinder replacements depending on the setup.
Rear drum vs rear disc considerations
Identifying whether your CR-V has rear discs or drums is important because it determines whether you buy pads or shoes and can affect labor costs and replacement intervals. Always verify your specific vehicle configuration before buying parts.
Always verify your vehicle’s rear brake type to ensure you’re ordering the correct parts. The CR-V’s rear brakes can differ by trim level and production date.
Installation and total cost considerations
Labor costs can add significantly to the total depending on where you go, and whether you replace rotors at the same time. The following ranges reflect typical shop prices in the United States as of 2024–2026.
- Professional installation (per axle): roughly $90–$150, depending on location and shop rate.
- Parts and labor for both front and rear (if both brakes are disc brakes and rotors aren’t required): commonly around $180–$350 per axle, or about $360–$700 for both axles.
Shopping around, you may find less expensive promotions or discount retailers that offer brake pad sets with limited warranties. If you need rotor resurfacing or replacement, expect additional costs.
What to consider when buying brake pads
To ensure you get the right pad for your 2010 CR-V, consider material, noise level, dust, and warranty. OEM or high-quality aftermarket pads typically come with a warranty and may include wear sensors depending on the kit.
Regardless of the price, it’s important to have brake pads installed by a qualified technician if you’re unsure about the job, and to perform a full brake system check after installation.
Summary
For a 2010 Honda CR-V, expect front brake pad sets to cost roughly $30–$110 per axle depending on material, with rear pads disc variants at about $25–$90 per axle. If your rear brakes are drums, plan for shoes instead of pads, typically $20–$60. Labor adds to the total, commonly $90–$150 per axle in many markets. Always verify your vehicle’s exact brake configuration and shop around for best pricing and warranties.