Approximately 4.7 quarts of engine oil with the filter for the 1.4L turbo engine used in the 2019 Trax.
Oil capacity for the 2019 Trax
The 2019 Trax is powered by a 1.4-liter turbocharged engine. The official oil capacity with a new oil filter installed is 4.7 quarts (4.4 liters). This figure reflects a standard drain-and-fill oil change with the filter replaced. If you don’t replace the filter, the amount needed for a full fill can vary, so always verify with the owner’s manual or GM service data before starting.
The following values reflect the standard capacity for a typical oil change on this model year and engine. Always confirm against your vehicle’s specific manual or a dealership if you have a VIN-based variation.
- 4.7 quarts (4.4 L) of engine oil with filter
After adding oil, check the level with the dipstick and top up only to the full line as needed. Run the engine briefly, recheck for leaks, and re-check the level once cool.
Maintenance notes
Use a Dexos1 Gen 2 compliant oil and follow the viscosity recommended in your owner’s manual for your climate. For precise service intervals and any regional variations, consult GM’s official guidance or your dealer. Oil capacity remains the same for the standard 1.4L turbo configuration, but always verify if you’ve modified the engine or if a non-standard specification applies.
Bottom line and quick tips
Plan to have about 5 quarts available to cover small variances and spills, but the standard capacity for a full oil change on a 2019 Trax with the 1.4L turbo engine is 4.7 quarts with the filter.
Summary: The 2019 Chevy Trax’s 1.4L turbo engine requires about 4.7 quarts of engine oil with the filter installed for a typical full oil change. Always confirm the exact spec in the owner’s manual or GM service data, as regional differences can occur and to ensure you use the correct oil grade and capacity.