The 2.4-liter engine in the Jeep Renegade typically requires about 5 quarts of engine oil with a new filter. That’s roughly 4.7 liters. Use this as a baseline, but always verify your exact figure in the owner's manual or on the oil fill cap for your specific model year.
The Renegade’s 2.4L Tigershark engine has a standard oil capacity that can vary slightly by year and by whether the oil filter is changed. Understanding the precise capacity helps prevent overfilling or underfilling, which can affect engine performance and longevity.
Oil capacity basics
Before you begin a change, consider the following to understand how the capacity translates to maintenance practicalities.
- Capacity with filter change: about 5 quarts (approximately 4.7 L).
- Capacity without replacing the filter: generally not recommended as a comparison; the practical refill figure centers on 5 quarts when the filter is installed.
- Variations by year or model: some minor differences can occur depending on the exact Renegade trim or production year.
- After-change check: always recheck the oil level with the dipstick after the engine runs and cools to ensure it’s at the full mark.
In practice, most owners find that the engine gets a full, correct oil level with about 5 quarts during a standard oil-and-filter service. If your dipstick shows a level toward the low side after the first check, add gradually in small increments and recheck to avoid overfill.
Oil specification and grade
Choosing the right oil grade and specification is essential for performance and protection of the 2.4L Tigershark engine in the Renegade.
- Viscosity: typically 5W-30 for most climates and driving patterns. Some regions or temperatures may allow 0W-20 or 5W-20; consult your manual for the recommended grade in your area.
- Oil type: synthetic blend or full synthetic is acceptable and commonly recommended for this engine.
- Specifications: use oil that meets Mopar MS-6395 guidelines and API SN (or later) service categories; many owners opt for oils labeled as meeting Chrysler/Jeep certification.
Following these specifications helps ensure proper lubrication, cold-start protection, and engine cleanliness over the service interval.
Oil change checklist
To carry out an oil change correctly, follow these steps in order and confirm each stage before moving on.
- Warm the engine briefly to circulating temperature to help the oil drain more completely.
- Secure the vehicle on level ground, with the parking brake engaged and the engine off.
- Drain the old oil from the sump and remove the old oil filter, disposing of them properly.
- Install a new oil filter and refill with the recommended amount of oil (about 5 quarts with filter).
- Run the engine, check for leaks, then recheck oil level on the dipstick and top off if necessary to reach the full mark.
Following these steps helps ensure a clean, accurate oil change and helps protect the engine going forward.
Summary
For a Jeep Renegade with a 2.4L engine, the typical oil capacity is about 5 quarts with a new filter (roughly 4.7 liters). Use 5W-30 oil in a synthetic blend or full synthetic meeting Mopar MS-6395, and verify the exact capacity and grade in your owner’s manual. When in doubt, double-check the dipstick after refilling and adhere to proper disposal guidelines for used oil and filters. Regular, correctly performed oil changes support engine longevity and reliable performance in this compact SUV.