In a 2016 Jeep Patriot, the oil filter is mounted on the engine block and its exact location varies by engine option. Most Patriots from this year place the filter on the side of the engine, either in a spin-on canister or inside a removable cartridge housing. Check your engine type to confirm the precise spot.
Engine options and filter design
The 2016 Patriot could be equipped with either a 2.0-liter World engine or a 2.4-liter Tigershark engine. Each uses a different filter configuration, but both are accessible from the engine bay.
2.0-liter World engine
- Location: The oil filter is mounted on the side of the engine block, typically toward the passenger side, in a vertical canister.
- Access: Remove the canister cap with an appropriate wrench and pull the old filter element out; replace with a new filter and reseal the cap.
The 2.0-liter World engine typically presents a straightforward spin-on filter on the side of the block, making replacement relatively simple with basic tools.
For the 2.4-liter Tigershark engine, look for a different side location and housing.
2.4-liter Tigershark engine
- Location: The oil filter is on the side of the engine, often on the driver’s side, inside a small cylindrical housing.
- Access: Depending on the design, it may be a cartridge inside a housing with a removable cap or a similar canister; follow the service manual for cartridge replacement or cap removal.
The 2.4-liter Tigershark may use a cartridge-style filter inside a housing, which requires removing the housing cap to replace the cartridge.
Note: The exact layout can vary by trim or market. When in doubt, consult the owner's manual or a VIN-specific repair guide to confirm the precise position and the correct filter type.
How to locate and replace
Once you know the general area, use these steps to locate and replace the oil filter on a 2016 Patriot. They apply to both engine types with minor variations in the filter type.
- Park the Jeep on a level surface, engine off and cool. Engage the parking brake.
- Open the hood and locate the oil pan; trace upward to identify the filter housing on the engine side (passenger or driver side depending on engine).
- For a spin-on canister, use a filter wrench to turn the cap counterclockwise and remove the old filter; for a cartridge filter, remove the housing cap to access the cartridge.
- Install a new filter of the same specification, reseal the cap, and replace the sump drain plug gasket if necessary. Refill oil to the correct level.
- Start the engine and check for leaks; recheck oil level after a few minutes of idle.
If you cannot locate the filter or are unsure of the car's engine, consult a professional. The dealership or a VIN-specific service guide will confirm the exact location and replacement procedure.
Summary
The oil filter on a 2016 Jeep Patriot is mounted on the engine block and its exact location depends on the engine choice. For the 2.0-liter World engine, look on the passenger side in a vertical canister; for the 2.4-liter Tigershark, check the driver’s side in a cylindrical housing. Always verify with the owner's manual or a VIN-specific service guide for the precise location and filter specification.