The 2019 Chevrolet Traverse with the 3.6-liter V6 engine requires about 5.7 quarts of engine oil for a full change, including the new filter. Always verify with the owner’s manual and check the level on the dipstick after filling.
Official capacity and recommended oil
Understanding the official specification helps with planning a proper oil change. The 3.6L V6 in the Traverse is listed as needing 5.7 quarts (5.4 liters) of oil when a new filter is installed. GM specifies Dexos1 Gen 2 0W-20 synthetic oil for this engine.
To guide your planning, consider the following details:
- Oil capacity (including filter): 5.7 quarts (5.4 L).
- Recommended oil: Dexos1 Gen 2 0W-20 synthetic.
- Typical change interval: about every 7,500 miles (12,000 km) under normal driving, with more frequent changes under severe conditions.
In practice, plan for about 5.7 quarts of oil for a standard change with a new filter and confirm the final level using the dipstick after the engine has settled.
Practical steps for oil changes and level checks
When performing the oil change, start from the recommended quantity and verify the level after the oil has circulated and the engine has cooled slightly. The following steps help ensure a correct fill and accurate dipstick reading.
- Park on a level surface and run the engine briefly to warm the oil, then turn it off and wait a few minutes.
- Drain the old oil and remove the old filter, disposing of them properly.
- Install a new filter and add 5.7 quarts of Dexos1 Gen 2 0W-20 initially.
- Run the engine for about a minute, then turn it off and let the oil settle for a few minutes.
- Check the oil level with the dipstick and top up in small increments until the level reaches the full mark.
Bottom line: start with 5.7 quarts, then verify and adjust as needed for a precise full level.
Why the capacity matters and caveats
Even though 5.7 quarts is the standard capacity, the exact amount can vary slightly due to filter size, draining efficiency, or any deviation from the standard filter used. Always rely on the dipstick after a change to confirm the correct level.
If you have any doubt, consult the owner’s manual or contact a Chevrolet dealer for guidance specific to your VIN and engine build.
Summary
The 2019 Chevy Traverse 3.6L typically takes 5.7 quarts of engine oil with a new filter. Use Dexos1 Gen 2 0W-20 oil, and verify the final level with the dipstick after the oil has settled. Following the manufacturer’s recommendations helps ensure optimal engine lubrication and longevity.