The official engine oil capacity for the 2015 Chevrolet Traverse with a 3.6-liter V6 is six quarts (5.7 liters) when performing an oil change with a new filter.
Understanding this figure is important for proper maintenance. The 3.6 L V6 used in this model requires 5W-30 oil and the total capacity includes the oil required by the filter. This article summarizes the official specification and provides practical guidance for routine changes.
Official capacity and what it includes
What the capacity covers
GM's owner manuals and Chevrolet maintenance references specify the 6-quart figure as the total oil needed when you replace the oil filter. The metric equivalent is about 5.7 liters. This means you should plan to add roughly 6 quarts during an oil change with a new filter, then verify the level with the dipstick after running the engine and letting it cool.
Before performing a change, know that this capacity refers to a standard, factory-fitted filter and a full oil change. The exact amount can vary slightly with aftermarket filters, but the official specification assumes a typical OEM filter size.
Key numbers you should know about the oil fill for this engine:
- Oil capacity with filter: 6 quarts (5.7 liters)
- Recommended oil viscosity: 5W-30
- Oil capacity without filter: about 5.3 quarts (varies by filter size)
- Suggested fill practice: begin with 6 quarts, then check the dipstick and top off if needed
In practice, aim to fill to the full mark after the engine has settled for a moment, then recheck and adjust as necessary for an accurate reading.
Practical tips for the oil change
When you perform an oil change on a 2015 Traverse, use a clean filter, meet the 5W-30 specification, and recycle used oil properly. Start the engine, run it for a minute, then shut it off and recheck the level after about five minutes of stationary time.
Summary
The 2015 Chevy Traverse with a 3.6 L V6 calls for about 6 quarts (5.7 liters) of engine oil when changing the oil with a new filter, using 5W-30 oil. Verify the level with the dipstick after the engine has cooled and the oil has settled.