The engine requires 4.5 quarts of oil with the filter installed.
The 2014 Dodge Avenger uses the 2.4 L Tigershark four-cylinder, and this article explains the official capacity, what it covers, and how to verify the proper fill level after an oil change.
Official oil capacity
For the 2.4 L Tigershark engine in the 2014 Avenger, the standard oil capacity is 4.5 quarts with the filter. This is the amount recommended for a complete oil change that includes replacing the filter, ensuring proper lubrication and pressure.
Variations and practical considerations
The exact quantity can vary slightly depending on factors such as the specific oil filter used, the engine’s temperature, and whether you are performing a full change with a new filter or a simple drain-and-fill. When in doubt, rely on the dipstick as the final check and top off gradually to reach the correct level.
How to verify the level after a change
After changing the oil, run the engine briefly, turn it off, and let the oil settle. Check the dipstick and add oil in small increments until the level sits between the minimum and maximum marks. Recheck once more after a short idle to confirm stability.
Summary
The official oil capacity for the 2014 Dodge Avenger 2.4 L is 4.5 quarts with the filter installed. Always confirm with the owner’s manual for your exact vehicle configuration and verify the level with the dipstick after any oil change.
Can I use 5W-30 instead of 5W20 in my Dodge?
Using 5W-30 instead can reduce fuel economy and impede flow throughout the engine. While using it temporarily in a pinch likely won't cause your engine lasting harm, remember that the engineers who built your engine did so with a specific viscosity oil in mind, meaning it's best to stick with it.
Can I make my Dodge Avenger faster?
If you want to improve the performance, you can use a simple Dodge upgrade: Pedal Commander®. This Dodge performance part will enhance the response of your throttle pedal, giving you more speed without putting your engine at risk.
What kind of oil does a Dodge Avenger 2.4 take?
5W-20
2010 Dodge Avenger 2.4L Complete Oil, Air & Cabin Filter Kit (5W-20)
How much oil does a 2014 Dodge Avenger 2.4 L take?
Oil Grade: SEO11
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Torque: | 30 ft/lbs (Oil Drain Plug) |