The 2013 Silverado with the 5.3-liter V8 typically takes about 8 quarts of engine oil when performing a full change with a new filter, and about 6 quarts if you’re not replacing the filter. Always verify the exact figure for your specific engine code and drivetrain configuration in the owner’s manual or GM service data.
Official figures and variations
Oil capacity can vary slightly depending on the exact engine code and whether the filter is included in the fill. The following figures cover common scenarios for the 2013 Silverado 5.3L V8.
Before you rely on these numbers, check your vehicle’s manual or service data for the precise specification tied to your VIN.
- Oil capacity with the oil filter installed: about 8 quarts (approximately 7.5–8.0 quarts depending on exact configuration).
- Oil capacity without the oil filter: about 6 quarts.
In practice, start with the larger figure if you’re changing the filter, then check the level with the dipstick after a short idle and re-tighten or add oil as needed to reach the correct level.
Considerations by engine variant
GM used a few slightly different 5.3L configurations across the 2013 model year. While the general guidance remains around 8 quarts with a filter, and about 6 quarts without, exact amounts can vary by engine code and drivetrain details. When in doubt, consult the dealer or the official GM service data for your exact VIN.
How to perform a safe oil change (brief guide)
To ensure you fill to the correct level and avoid overfilling, follow a standard oil change procedure and verify with the dipstick at the end.
- Run the engine briefly to warm the oil, then turn off and let it settle.
- Drain the old oil and replace the oil filter with a new one.
- Begin by adding the upper-end capacity (about 7.5–8 quarts for a filter change) in increments, then recheck the level.
- Start the engine and run for a minute, then turn off and recheck the dipstick.
- Continue adding small amounts as needed until the dipstick reads within the recommended range.
Always use the recommended oil type and viscosity for your engine as specified in the owner’s manual and GM service data.
Summary
For a 2013 Chevrolet Silverado with the 5.3L V8, plan for roughly 8 quarts of oil when changing the filter, or about 6 quarts if not replacing the filter. Exact figures can vary slightly by engine code and configuration, so verify with the manual or GM service data for your specific vehicle. Regularly check the dipstick to ensure an accurate fill and proper engine lubrication.