About 5.5 quarts with a new oil filter.
For the 2010 Town & Country powered by the 4.0-liter Magnum V6, the standard engine oil capacity is typically 5.5 quarts when you replace the filter. The capacity figure reflects a full oil change with a new filter, and you should verify the exact amount using the vehicle’s owner’s manual and the dipstick during service.
Oil capacity and specifications
Key numbers and practical notes you’ll want to know before an oil change.
- Capacity with a new oil filter: 5.5 quarts
- Capacity without replacing the filter: approximately 5.0 quarts
- Recommended viscosity: 5W-20 for most conditions; 5W-30 may be used in warmer climates or when specified by the owner's manual
These figures reflect typical service guidance for the 4.0L engine in the 2010 Town & Country. Always consult the owner’s manual or a dealer for VIN-specific specifications and any updates to recommended maintenance practices.
Practical steps for a safe oil change
Before you change the oil, gather the right tools and follow a clear procedure to ensure a safe, clean change.
- Warm up the engine briefly, then turn it off and engage the parking brake.
- Place a drain pan beneath the oil pan and remove the drain plug to drain the old oil.
- Remove and replace the oil filter with a new one designed for the 4.0L engine.
- Reinstall the drain plug and add the recommended amount of new oil (start with 5 quarts, then check the level).
- Check the oil level with the dipstick, adding small amounts as needed until the level reaches the full mark.
After the oil change, run the engine briefly, check for leaks, and recheck the oil level once the engine is fully cooled.
Summary
For the 2010 Chrysler Town and Country with the 4.0L engine, plan on about 5.5 quarts of engine oil with a new filter. Use 5W-20 as the baseline viscosity, with 5W-30 as an alternative in certain climates or as specified by your manual. Always confirm exact capacity and viscosity for your vehicle’s VIN in the owner’s manual.
What oil does a 4.0 V6 use?
Over to our computer you can see that this vehicle requires 5 quarts of 5W30 premium synthetic blend and for this vehicle we'll be using the Carquest Romeo 85372 oil filter let's get to it.
Can I use 5W30 instead of 5W20 in my Chrysler?
Only switch if your owner's manual approves. Using the wrong oil can affect engine performance and longevity. Moving from 5W20 to 5W30 adds protection but might reduce efficiency. Going from 5W30 to 5W20 could lessen engine protection, especially during Lansing's temperature extremes.
What kind of oil does a 2010 Town and Country Minivan take?
Valvoline – Advanced Full Synthetic 5W-20 Motor Oil, Maximizes Engine Life, 5 Quart (Part No. 881147)
How many quarts of oil does a 2010 Town and Country with a 4.0 take?
5.5 quarts
Engine Oil
Capacity: 5.5 quarts (with filter).