The engine requires about 4.5 quarts of oil for a full change with a new filter. This is the official capacity Honda lists for the 2008 Accord’s 2.4-liter four-cylinder engine. After draining the old oil, you may need to add a bit to bring the level up to the full mark on the dipstick.
Oil capacity in brief
Before listing the precise figure, here is the key capacity you should plan around when performing an oil change on this model.
- 4.5 quarts (approximately 4.3 liters) of engine oil, when changing the oil and filter.
In practice, you might not drain every drop from the engine and some oil may remain in the crankcase, so you should check the dipstick and top off as needed to reach the full mark.
Oil type and viscosity recommendations
Choosing the right oil ensures proper lubrication and performance for the 2.4 L engine. The following guidelines reflect common Honda recommendations for this era of Accord. Always confirm with your owner’s manual or a trusted dealer for your specific climate and usage.
- 5W-20 is the typical recommended viscosity for most climates, and it can be synthetic blend or full synthetic.
- Use an oil that meets or exceeds API standards and Honda specifications; if in doubt, select a quality synthetic or synthetic-blend oil from a reputable brand.
After selecting oil, remember to replace the oil filter with a OEM or equivalent quality part to maintain proper filtration and capacity during the change.
Practical steps for a standard oil change
Before starting the process, gather supplies and prepare the vehicle. The following checklist outlines a straightforward approach to changing the oil on a 2008 Accord 2.4 L.
- Warm up the engine briefly, then turn it off and secure the vehicle on level ground.
- Drain the old oil from the pan and replace the drain plug gasket if needed.
- Replace the oil filter with a new one suitable for the engine.
- Pour in the recommended amount of oil (about 4.5 quarts with filter) and inspect for leaks.
- Check the oil level with the dipstick, add small amounts if needed, and recheck until the level is at the full mark.
For precise steps and torque specifications, consult the owner’s manual or have the oil change performed by a qualified technician.
Summary
The 2008 Honda Accord 2.4 L typically takes 4.5 quarts of engine oil when performing an oil change with a new filter. Use 5W-20 viscosity as the standard recommendation and ensure the oil meets Honda’s specifications. Always verify the level with the dipstick after the change and adjust as needed to reach the full mark.