The engine typically takes about 4 quarts of oil when performing a full change with a new filter.
For the 2008 Civic with the 1.8-liter i-VTEC engine, the standard oil capacity is around 4.0 quarts (roughly 3.8 liters) when you replace the oil and filter. After draining, you’ll refill to the full mark on the dipstick. The exact amount can vary slightly by vehicle condition, local oil grade, and climate. Honda commonly recommends 5W-20 oil for this engine, though some markets may use 0W-20; always verify with the owner's manual or the service data for your specific car.
Official oil capacity for the 2008 Civic 1.8L
Before the list, this figure represents the typical capacity cited for a standard oil and filter change on the 1.8L engine. The commonly referenced value is:
- 4.0 quarts (approximately 3.8 liters) of engine oil with the filter change.
Concluding from this list, 4.0 quarts is the practical guideline for most owners performing a standard oil change. Always use the dipstick to confirm the level and adjust as needed.
How to perform the oil change (brief steps)
Before the list, here are concise steps if you’re doing the change yourself. Following these helps ensure you reach the correct level and maintain engine health.
- Warm up the engine briefly, then park on level ground and turn off the engine.
- Drain the old oil by removing the drain plug and allow the oil to completely drain into a suitable pan.
- Remove and replace the oil filter with a new one; lubricate the gasket with a bit of new oil before installing.
- Reinstall the drain plug securely and begin adding new oil a little at a time.
- Add up to 4.0 quarts initially, then recheck with the dipstick. Start the engine, run briefly, turn off, wait a moment, and recheck the level; top up if necessary to the full mark.
Concluding: Dispose of used oil and the old filter responsibly, and double-check for leaks after the engine has run.
Summary
The 2008 Honda Civic 1.8L generally requires about 4.0 quarts of engine oil when performing an oil and filter change, using the recommended 5W-20 (or in some markets 0W-20). Confirm the exact amount with your owner's manual and your dipstick, and follow proper procedure to complete a clean, safe oil change.