The 2009 Honda Fit takes about 3.7 US quarts of engine oil when performing a full oil change with the filter installed.
This figure comes from Honda’s official engine oil capacity specification for the early Fit’s 1.5-liter four-cylinder engine. It represents the amount needed after draining the old oil and replacing the filter. Real-world amounts can vary slightly depending on the filter type, oil viscosity, and how close you are to the proper level when you finish topping up. Always verify the level with the dipstick as you add oil.
Oil capacity for the 2009 Honda Fit
The 2009 Fit uses a 1.5-liter four-cylinder engine. Honda lists the engine oil capacity as 3.7 quarts (3.5 liters) with the oil filter in place, which is the standard quantity recommended for a typical oil change.
With the oil filter installed
3.7 US quarts is the standard amount when replacing the oil and installing a new filter. This ensures the engine has enough lubrication after the old oil and filter have been removed.
Without the oil filter
The capacity without a filter is lower than 3.7 quarts. In practice, most maintenance procedures account for the filter, so technicians plan for roughly the full 3.7-quart total when the filter is changed as well. If you are not replacing the filter, consult the manual or a professional to determine the exact figure for your situation.
Notes for accurate maintenance
Always confirm the level with the dipstick after adding oil, and adjust in small increments to reach the full mark. If you’re using aftermarket filters or different oil formulations, the total capacity can vary slightly. When in doubt, reference the owner’s manual or contact a Honda service professional for the precise specification for your vehicle.
Summary
For a 2009 Honda Fit, plan on about 3.7 quarts of engine oil with the filter installed during a standard oil change. Verify the level with the dipstick and refer to the owner’s manual for your exact maintenance guidance.