The 2008 Honda Accord holds about 4.5 quarts of engine oil in the four-cylinder version and roughly 5.0 quarts in the V6 version, including the filter. This varies by engine option, so it’s important to know which powerplant your car uses.
The quantity depends on the engine installed in the car. The 2008 Accord was offered with two engines—the 2.4-liter inline-4 and the 3.0-liter V6—and each has its own oil capacity. Below is a concise breakdown and practical guidance for checking and maintaining the oil level.
Engine oil capacity by engine
Identify your engine to determine the exact capacity. The figures below assume a full oil change with a new filter installed.
- 2.4L inline-4: 4.5 quarts (with filter)
- 3.0L V6: 5.0 quarts (with filter)
These numbers reflect the total oil capacity needed when changing the oil and replacing the oil filter. If you’re topping off between changes, use a conservative amount and recheck with the dipstick.
Why capacity differs
The difference in capacity comes from the engines’ physical size, oil pan volume, and lubrication requirements. The larger V6 engine carries more oil, which helps ensure adequate lubrication under heavier loads and longer service intervals. Always rely on the engine type listed in your owner’s manual or under-hood labeling for exact figures.
Practical guidance for checking and maintaining oil levels
Properly maintaining oil levels is essential for engine longevity. Here are practical steps to ensure you stay within the recommended range.
- Park on level ground and turn off the engine. Wait several minutes for the oil to settle.
- Locate and remove the dipstick, wipe it clean, reinsert, then remove to read the level.
- If the level is low, add oil in small increments (about a half-quart at a time), recheck, and repeat as needed until you’re near the full mark.
- Use the correct oil grade recommended for your engine and climate, and replace the oil filter during a full change.
Regularly checking the oil level and using the proper quantity helps prevent mid-cycle oil depletion and supports optimal engine performance.
Summary
For a 2008 Honda Accord, engine oil capacity depends on the engine type: about 4.5 quarts for the 2.4L four-cylinder and about 5.0 quarts for the 3.0L V6, both with the filter. Confirm the exact figure by checking your owner’s manual or the under-hood sticker, especially if you’re unsure which engine your car has. Proper maintenance includes using the right oil grade and routinely checking the dipstick to avoid overfilling or running low.
What type of oil does a 3.5 L V6 take?
2.7L & 3.5L EcoBoost V6: 5W-30 synthetic.
How much oil does a 2008 4.3 L V6 take?
Capacity: 4.5 quarts (with filter). After refill check oil level.
What kind of oil does a 2008 Honda Accord V6 take?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Capacity: | 4.2 quarts. w/of. After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) |
What year is the fastest V6 accord?
2004
The fastest Honda Accord ever was a 2004 V6 model, which delivered a 0-60 mph time of just 5.9 seconds.