The engine oil capacity for the 2014 Honda Accord with the 2.4L four-cylinder is about 4.5 quarts when you perform an oil change with the filter replaced (roughly 4.3 liters).
Keep in mind that the capacity changes if you drain only the oil and don’t replace the filter, which reduces the quantity to about 4.0 quarts. Always verify with the dipstick after a change and consult the owner's manual for exact guidance based on your car’s condition and regional specifications.
Oil capacity figures
Before performing an oil change, understand the standard figures and how they apply depending on the service performed on the 2014 Accord 2.4L.
- With filter change: 4.5 quarts (approx. 4.3 liters).
- Without filter change: 4.0 quarts (approx. 3.8 liters).
Note: These figures assume the use of the recommended oil grade and a stock factory filter. Aftermarket filters or engine variants can cause slight variations.
Specifications and maintenance tips
Recommended oil type and viscosity
Honda generally specifies 0W-20 synthetic oil for the 2014 Accord 2.4L under normal driving conditions. This helps with fuel efficiency and cold-start performance. In extreme climates or high-mileage applications, some technicians may consider approved alternatives, but you should verify with your owner's manual or dealer.
How to check the oil level and top up
After an oil change, run the engine briefly, turn it off, and wait several minutes for the oil to settle. Check the dipstick to ensure the level is between the MIN and MAX marks. If low, add small increments of the correct oil type and recheck until you reach the full mark—avoid overfilling, which can harm engine performance.
Summary
For a 2014 Honda Accord with a 2.4L engine, plan on about 4.5 quarts of oil when performing a standard oil change with a new filter. If you skip the filter replacement, the capacity is closer to 4.0 quarts. Use the recommended 0W-20 synthetic oil, and always verify the final level with the dipstick after refilling.