Typically about 700 ml of CVT gear oil is needed for a full change on Honda Click models, though exact capacity depends on the specific model and year. Always verify with the owner's manual or a dealer.
The Honda Click family uses a CVT (continuously variable transmission) that requires a dedicated CVT oil separate from the engine oil. The precise amount you need can vary slightly by model and year, so consult the manual for your exact figure. For many recent Click variants, the practical refill amount sits in the 0.6–0.8 liter range when performing a full drain and refill.
CVT oil capacity overview
To give you a practical reference, the following range covers most Honda Click scooters as they come from the factory and during standard maintenance:
- Typical CVT oil capacity: about 600–800 ml (0.6–0.8 L) for a full drain and refill
Note: This is a general guide. Check the exact specification in your owner’s manual for your model/year, or ask your Honda dealer for the precise quantity.
Steps to replace CVT oil on a Honda Click
Before performing a CVT oil change, make sure you have the right tools and the correct specification of oil. The steps below describe a typical drain/refill process for a scooter CVT. Always follow the service manual for torque specs and exact steps.
- Position the scooter securely on a stand and warm up the engine briefly, then turn it off.
- Place a drain pan beneath the CVT oil drain plug and carefully remove the plug to drain the old oil.
- Once drained, reinstall the drain plug with a new washer and tighten to the specified torque.
- Using a funnel, add the recommended CVT oil amount (about 700 ml) or until the level reaches the specified mark on the dipstick or sight gauge.
- Run the engine at idle, cycle through the gears a few times, then re-check the level and top up if needed.
Proper CVT oil type and exact capacity are critical for optimal performance and longevity of the transmission. If you are unsure, have a trained technician perform the service.
Summary
For most Honda Click scooters, plan on about 700 ml of CVT gear oil for a full drain and refill, with typical ranges between 600 and 800 ml depending on model/year. Always verify with the owner's manual or a dealer, and use the oil specified by Honda for CVT systems.