About 750 ml of engine oil for a full change, typically in the 700–800 ml range, and up to 850 ml if you replace the oil filter.
For the Honda Click 160, the exact oil quantity can vary slightly by model year and market. This article outlines the typical capacity, recommended oil grades, and a step-by-step guide to performing the change safely and effectively.
Oil capacity and grade for the Honda Click 160
The engine oil capacity for a complete drain-and-fill is generally around 0.75 L (750 ml). If you also replace the oil filter, expect to use up to about 0.85 L (850 ml). The precise amount can differ by year and variant, so consult the owner’s manual or service bulletin for your specific bike if possible.
Before listing the specifics, note the following about oil grades and standards commonly used with the Click 160:
- Oil capacity (drain and fill, including filter): approximately 0.75 L (750 ml); with a new filter: about 0.85 L (850 ml).
- Recommended viscosity: typically 10W-30 or 10W-40, depending on climate; always match to the manufacturer’s guidance for your market.
- Required standards: look for oils that meet JASO MA/MA2 and API SN or better; many riders use Honda GN4 or other reputable brands that meet these specs.
- Climate considerations: cooler environments may benefit from the lower end of the viscosity range (e.g., 10W-30), while hotter climates may require 10W-40 for better protection.
In practice, you should verify the exact figure for your bike’s year and regional variant and ensure the oil you choose meets the JASO and API specs recommended by Honda for the Click 160.
Step-by-step oil change procedure
Before performing the oil change, gather the right tools and materials, and follow a careful sequence to ensure a clean, complete job.
- Warm up the engine briefly to let the oil drain more easily, then park the scooter on a center or side stand on a stable surface.
- Place a drain pan beneath the drain bolt, remove the drain bolt, and allow the old oil to completely drain out.
- Remove the oil filter (if equipped) and replace with a new filter; apply a thin film of new oil to the gasket to ensure a proper seal.
- Reinstall the drain bolt with a new washer, tighten to the specified torque, and wipe away any drips.
- Pour in the recommended amount of fresh oil (starting with about 0.75 L, then checking level) and replace the oil filler cap.
- Run the engine for a short period, shut it off, and check for leaks; wait a few minutes for the oil to settle, then check the oil level with the dipstick and top up if needed to reach the correct mark.
- Dispose of the old oil properly at an approved collection point and record the service in your maintenance log.
Following these steps helps ensure the engine is properly lubricated and that the oil level is accurate after the change.
Final considerations and tips
- Always refer to the latest Honda service information for your exact Click 160 model year and market, as capacities can vary slightly.
- Use a quality motor oil that meets JASO MA/MA2 and API SN or better; many riders prefer Honda GN4 or equivalent brands suitable for 4-stroke scooter engines.
- If you are unsure about the filter replacement, err on the side of replacing the filter during a major oil change to maintain optimal protection and filtration.
Summary
The Honda Click 160 typically requires about 0.75 L (750 ml) of engine oil for a full change, with up to around 0.85 L (850 ml) if the oil filter is replaced. Choose an oil that meets JASO MA/MA2 and API SN or better, and select the viscosity based on climate (commonly 10W-30 or 10W-40). Always verify exact capacity for your model year and market, perform the change with proper procedure, and recycle used oil responsibly. A careful refill and level check are essential to maintaining engine health over time.