The quick answer: inflate all tires to the recommended cold pressures and drive for a short period; in most Honda models, the TPMS will relearn automatically. Some models or years require a manual reset via a dedicated button or the vehicle’s settings menu.
Tire Pressure Monitoring Systems (TPMS) in Honda vehicles alert you when a tire’s pressure is significantly low. When you adjust tire pressures after a flat, replacement, or seasonal change, you typically need the system to relearn the new levels. The exact method can vary by model year, so it’s helpful to know both automatic relearn processes and any model-specific manual reset steps. This guide covers common Honda practices and where to find model-specific instructions.
Automatic relearn: drive-to-learn (no manual reset required)
In most Honda models, once you’ve inflated each tire to the recommended cold pressure, the TPMS relearns automatically as you drive. This usually happens after a short period of normal driving, and no button press is required.
- Inflate all four tires to the recommended cold pressures listed on the door placard (not the tire sidewalls). Recheck after letting the tires sit for several minutes if you’ve recently driven or warmed them up.
- Ensure the vehicle is parked on a level surface and the tires have cooled for several minutes before inflating.
- Drive the vehicle at a steady speed for 10–20 minutes (often at highway speeds) to allow the TPMS to relearn the new pressures.
- Observe the TPMS warning light: if it goes out after the drive, the relearn is complete. If the light remains on, confirm all pressures are correct and retry the drive cycle or proceed to a manual reset if your model supports it.
- If the light stays on after a proper relearn attempt, check for tire leaks, damaged sensors, or faulty valve stems, and consult a dealer or tire shop.
Before starting the list, note that the following steps describe the general automatic relearn approach used by many Honda vehicles. Always verify with your owner’s manual for your exact model/year.
The automatic relearn method is the simplest and most common path for modern Hondas. It requires no special tools or menu navigation beyond inflating to the correct pressures and driving for a while.
Manual TPMS reset: when a button or menu reset is needed
Some Honda models or specific model years—especially older examples or those with certain trims—may require a manual reset. This usually involves a TPMS button or the vehicle’s settings menu to initiate a learn cycle.
- Locate the TPMS reset button: common locations include under the left side of the dash, near the steering column, inside the glove box, or in the center console. If you can’t find it, check the owner’s manual for the exact location for your model/year.
- With the ignition in the ON position (engine off) or according to your manual, press and hold the TPMS/SET button until the TPMS indicator light blinks, changes, or a confirmation message appears on the instrument cluster. Release the button.
- Drive at a moderate speed for 10–15 minutes to complete the learning process. The TPMS light should either turn off or indicate a successful relearn.
- If the light does not behave as expected after the reset, recheck tire pressures and sensor integrity, or consult a Honda dealer for a sensor check or replacement.
Before attempting the manual reset, ensure the tires are inflated to the recommended cold pressures. Then follow the model-specific steps below.
Keep in mind: not all Honda models support a manual TPMS reset. Many newer Hondas rely exclusively on the automatic relearn process, and attempting a manual reset in such vehicles may have no effect. Always refer to the owner’s manual for model-specific instructions.
What to do if TPMS light stays on after reset attempts
A persistent TPMS warning after attempting both automatic relearn and potential manual resets often points to a tire leak, a faulty sensor, or a damaged valve stem. Conduct a thorough tire inspection for punctures, cuts, or nails; check for slow leaks in the valve stems; and consider checking the sensor batteries if the vehicle is older. If in doubt, visit a Honda service center or a tire shop for a professional TPMS diagnostic.
Model-specific notes and tips
Because Honda has produced many models across multiple generations, the exact TPMS reset procedure can vary. For example, different trims or model years may place the reset button in slightly different places, or rely on the Settings menu’s Learn/Reset option rather than a dedicated button. If you’ve changed tires, rotated tires, or serviced sensors, consult your owner’s manual or contact a dealer to confirm the correct procedure for your vehicle.
Summary
Resetting TPMS after adjusting tyre pressure on a Honda typically requires inflating to the correct cold pressures and driving to allow automatic relearn, which is the standard method for most models. If your model supports a manual reset, you may need to use a TPMS button or the vehicle’s settings menu to initiate the learning cycle. When in doubt, verify steps in the owner’s manual or seek help from a Honda dealership or tire shop to ensure the system reports accurate pressures and remains reliable.
How much does Honda charge to reset TPMS?
The average cost for a Honda Accord Tire Pressure Monitoring System Relearn is between $49 and $72. Labor costs are estimated between $49 and $72. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
Where is the TPMS reset button on a Honda?
If your Honda is equipped with a TPMS button, you'll find it to the left of the steering wheel.
Why is my tire pressure light still on after filling tires on my Honda?
If the Honda low-pressure tire light is on in your car, truck, or SUV even after you've made sure that your tires have the correct amount of air, you'll need to reset the Tire Pressure Monitoring System (TPMS).
How long does it take for TPMS to reset Honda?
approximately thirty minutes
Honda TPMS Calibration Process
Pressing the TPMS button that is located on your steering column will start the process. Hold down the button until you see the indicator light blink twice. You'll need to drive your vehicle for approximately thirty minutes to recalibrate the system.