The quickest path to turning off a TPMS warning is to inflate all tires to the Honda-recommended pressures and perform a system relearn if your model supports it. If the light stays on, you may need a reset or sensor service.
What the TPMS light means
The Tire Pressure Monitoring System (TPMS) warns you when one or more tires are underinflated or when there is a fault in the system. On Honda vehicles, a solid amber light typically signals low tire pressure, while a flashing light can indicate a TPMS fault that requires diagnostic attention. The exact behavior can vary by model year and trim.
Direct vs indirect TPMS
Most newer Hondas use direct TPMS, which relies on sensors inside each tire. Some older models rely on an indirect TPMS method that estimates pressure from ABS wheel-speed data. Either approach can trigger the warning if a sensor battery is weak, a sensor is damaged, or a tire is underinflated.
Quick fixes to turn off the TPMS light
Start with the simplest checks that address non-diagnostic causes. If all tires are properly inflated and there are no leaks, the light should clear after a short drive or a relearn.
- Check each tire’s pressure with a reliable gauge, including the spare if your model monitors it. Compare readings to the recommended cold pressures found on the driver’s door jamb sticker or in the owner’s manual.
- Inflate each tire to the specified cold pressure. Use the value labeled as the target, not the maximum pressure printed on the tire sidewall.
- Recheck all tires after inflation. If any tire remains low, add air and recheck until all tires meet the spec.
After inflating to spec, drive the car for a few miles at normal speeds to allow the TPMS to relearn. If the light remains illuminated, use the reset/calibration procedure or proceed to professional service.
Resetting or calibrating the TPMS on a Honda
Because TPMS reset methods vary by model year and trim, use these guidelines as a starting point. If you cannot locate the exact steps in your owner’s manual, contact a Honda dealer or a tire shop for model-specific instructions.
- Use the TPMS reset button if your Honda is equipped with one. The button is often located under the dash to the left of the steering column or inside the glove box. With the ignition on (engine off), press and hold the button until the TPMS indicator in the instrument cluster blinks or confirms a relearn, then drive at 30–50 mph for about 10 minutes to complete the relearn.
- Use the vehicle’s Settings menu to perform a relearn. Navigate to Settings > Vehicle > TPMS Calibration (or Tire Pressure Monitoring System > Relearn) and follow the on-screen prompts. After completing the procedure, drive as instructed to finish the relearn.
- In some models, a relearn occurs automatically after you inflate all tires to spec and drive for a short period. If your model requires it, a dealer or tire shop can perform a professional recalibration with specialized equipment.
Note that exact steps depend on your Honda’s model year. If you can’t find the option in the menu or the reset button, consult the owner’s manual or a service professional for model-specific instructions.
When to seek professional help
If the TPMS light stays on after inflating and attempting a relearn, or if it begins to flash, a tire or TPMS fault is likely. A professional diagnostic can identify sensor or module problems and determine whether sensor replacement or system reprogramming is needed.
- Inspect tires for punctures, slow leaks, or obvious damage that could cause underinflation.
- Check the TPMS sensors and their batteries; sensor life typically ranges from five to ten years.
- Have a tire shop or Honda dealership diagnose with an appropriate TPMS tool and reprogram or replace sensors as needed.
Professionals can also confirm whether a spare tire is monitored on your model and ensure the entire system retrains correctly after tire changes or rotations.
Do's and Don'ts
Keep the TPMS in good working order by following best practices and avoiding common pitfalls.
- Do regularly check tire pressures when temperatures change and after long trips.
- Do perform a TPMS relearn after tire changes or rotations if required by your model.
- Don’t ignore a TPMS warning that persists after inflation and relearn attempts.
Summary
For most Hondas, the TPMS light goes off once all tires are inflated to the recommended pressures and the system completes a relearn. If the light remains on, or starts flashing, you may have a sensor or control-system fault that requires diagnostic tools used by tire shops or Honda service centers. Understanding your model’s reset options and keeping tire pressures in check helps prevent unnecessary warnings and keeps you safe on the road.
Where is the TPMS reset button on a Honda?
If your Honda is equipped with a TPMS button, you'll find it to the left of the steering wheel.
How much does Honda charge to reset TPMS?
The average cost for a Honda Accord Tire Pressure Monitoring System Relearn is between $49 and $72. Labor costs are estimated between $49 and $72. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
Why is my TPMS light on but tires are fine on my Honda?
One of the most common reasons for a TPMS light staying on despite the tires being properly inflated is a sensor malfunction. TPMS sensors are typically located inside the tire and can wear out or become damaged over time, particularly if you've hit a curb, driven through a pothole, or been off-road.
Does AutoZone fix TPMS sensors?
At AutoZone, we carry replacement TPMS sensors for most makes and models. And if you need help resetting the TPMS light, we can offer helpful advice or refer you to a shop in our professional network.