On a Jeep Renegade, the oil filter location varies with the engine installed. For most US-market Renegades with the 2.4L Tigershark, the oil filter is a spin-on canister mounted on the front/side of the engine block, typically near the passenger side and accessible from above after removing covers. In older or different-market models using the 1.4L MultiAir Turbo, the oil filter is cartridge-based and tucked in the valve-cover area under the intake manifold. Diesel variants and other configurations may differ; always confirm using your VIN and the owner's manual or service manual.
Engine variants and oil filter layouts
Identify your engine to determine where the filter is located. The following guide covers the main configurations you’ll encounter.
- 2.4L Tigershark (MultiAir 2) — Spin-on oil filter mounted on the front/side of the engine block, typically near the passenger side and sometimes behind a splash shield; you may need to move a shield or cover to gain access.
- 1.4L MultiAir Turbo — Cartridge-style filter inside a housing on the valve-cover side of the engine, under the engine cover and possibly the intake components; remove the cover and intake parts to reach it.
- 2.0L Multijet diesel (markets outside the U.S.) — Often cartridge-type, located in a compact housing on the engine block or near the firewall; check the service manual for exact coordinates.
Finding the exact location depends on your vehicle’s year and engine code. If in doubt, consult the owner’s manual or a dealership service bulletin for your VIN.
How to access and replace the oil filter (general steps)
These steps outline typical access paths for Renegade engines. Always follow the exact procedure in the service manual for your model and engine code.
- Park on a level surface, engage the parking brake, and allow the engine to cool before starting work.
- If needed, remove the engine cover and any surrounding shields or air intake components to expose the filter.
- If you have a spin-on filter, use a filter wrench to loosen and remove the canister; for cartridge filters, remove the housing cap to expose the cartridge.
- Install a new filter (and gasket for spin-ons) of the correct specification; hand-tighten the filter and reinstall any removed components.
- Refill with the specified oil, check for leaks, and verify the oil level after running the engine briefly and rechecking the dipstick.
These steps cover the typical approach for most Renegade engines; for your exact variant, consult the service manual or dealer guidance to avoid mistakes.
Always dispose of used oil and filters at an approved recycling facility or service shop.
Verification tips
For the most accurate location, verify your engine code: the code is on the engine tag near the top of the engine block or in the vehicle’s manual. VIN-based service manuals and forum guides for your exact year/model can provide precise photos and measurements.
Summary
The oil filter location on a Jeep Renegade is engine-specific. The common 2.4L Tigershark uses a spin-on filter mounted on the front/side of the engine block, while the 1.4L MultiAir Turbo uses a cartridge-style filter tucked under the valve-cover area. Diesel and other markets may differ. Confirm your engine code and consult the manual or a dealer to locate and replace the filter correctly.
Where is the engine oil filter located?
The oil filter is usually located beside the oil pan or under the hood of your vehicle near the engine. Place the collection pan under the filter. You can use a filter wrench to help remove.
What oil filter does a 2017 Jeep Renegade need?
Mopar Oil Filter 1.4L.
Where is the oil filter housing on a Jeep?
Now if you have a winch and a big old bumper like this one does it's going to be a bigger problem getting there and try to get this stuff done. But that's life with the Jeep.
Where is the oil filter on a Jeep Renegade 2016?
Off reach down with your. Hand. It'll come right up. So this is your oil filter right here um and that's the little canister it goes into now there's teeth on the top of it uh those teeth.