For tire changes or undercarriage inspections, use the Accord’s clearly marked lifting points: center points on the front and rear subframes for center lifting, and reinforced pinch welds along the rocker panels for side lifting. Following these official points helps prevent damage and keeps the vehicle stable while elevated.
Center and side jack points
The vehicle provides two categories of jacking points: center lift points on the front and rear crossmembers, and dedicated pinch welds on the rocker panels for side lifting. Use the center points with a floor jack, and the pinch welds when lifting a wheel on the side.
- Front center lift point on the front subframe crossmember (located behind the bumper area).
- Rear center lift point on the rear subframe crossmember (located near the trunk area).
When preparing to lift from the center points, position the jack squarely on the crossmember to prevent slipping and to distribute the load evenly.
There are four pinch-weld lift points along the rocker panels—two at the front and two at the rear—on both sides of the car.
- Left front pinch weld along the left rocker panel, just behind the front wheel.
- Right front pinch weld along the right rocker panel, just behind the front wheel.
- Left rear pinch weld along the left rocker panel, just behind the rear wheel.
- Right rear pinch weld along the right rocker panel, just behind the rear wheel.
When lifting from the sides, place the jack pad on the metal pinch weld—not on plastic trim or exhaust components. Always position supports such as jack stands at the same points before removing the jack.
Safety steps when jacking up the car
Before lifting the Accord, take these safety steps to prevent accidents. They cover preparation, stable lifting, and secure support once the vehicle is off the ground.
- Park on a flat, solid surface and engage the parking brake.
- Chock the wheels on the opposite side to prevent rolling.
- Place the jack on the correct lift point and ensure it is stable before lifting.
- Raise the vehicle only as high as needed and slip a jack stand under the same lift point; never rely on the jack alone.
- Lower the vehicle slowly onto the stands and remove the jack and tools.
Always maintain three points of contact when lifting and stay clear of the area above the vehicle while it is supported by stands. If you’re unsure or the surface is uneven, seek professional assistance.
Summary
The 2019 Honda Accord uses center lifting points on the front and rear subframe crossmembers for center lifts, plus rocker-panel pinch-weld points for side lifts. Use wheel chocks, proper jack stands, and follow the owner's manual for exact locations and any trim-specific differences. Safety and proper technique are essential for a successful tire change or inspection.