The reset approach for TPMS on a Honda Pilot varies by year and trim. In many models there isn’t a single universal reset button; you may either use a dedicated TPMS button if equipped or reset via the vehicle’s information display. After verifying tire pressures, you may also need to drive to relearn the sensor signals.
The exact location and steps depend on the generation of your Pilot. Older or base trims may include a small physical TPMS button on the left side of the dash, while newer models typically use a calibration option in the driver information display or touchscreen. Always consult your owner’s manual for the precise procedure for your specific year and trim.
Common locations and methods
Below are the two most typical approaches you’ll encounter on Honda Pilot models from different generations. Use the one that matches your vehicle.
Physical TPMS button (older or certain trims)
Some Honda Pilots retain a dedicated TPMS button on the driver's side dash. It is usually located on the left side of the instrument panel or near the hood release lever and is labeled "TPMS" or shows a tire icon. If your vehicle has this button, reset by pressing and holding it until the TPMS indicator blinks or you hear a confirmation, then drive to complete the relearn.
Note: If you don’t see a TPMS button, your vehicle likely uses the digital calibration method described below.
After performing the reset, plan to drive at a steady speed (roughly 30–60 mph) for about 10 minutes to allow the sensors to relearn. Make sure all tires are inflated to the recommended pressures before starting the relearn.
TPMS Calibration through the driver information display (newer models)
Newer Honda Pilots without a dedicated TPMS switch use the vehicle’s settings menu to recalibrate the system. You’ll typically navigate through the driver information display or infotainment screen: Home/Settings/Vehicle/TPMS Calibration or TPMS Reset. Select Calibrate or Reset, confirm, and then drive at a steady speed to complete the relearn process.
As with any reset, begin with correct tire pressures and follow the on-screen prompts closely. If you don’t see a TPMS Calibration option, consult the owner’s manual for your exact year and trim.
What to do if the TPMS light stays on
If the light remains on after resetting, re-check tire pressures to ensure each tire is at the recommended level. Inspect for punctures or slow leaks, and consider sensor issues or a dead sensor battery if pressures are correct and the light persists. In some cases, a technician may need to diagnose or replace a faulty TPMS sensor.
Summary
Resetting the TPMS on a Honda Pilot depends on the model year and trim. Some Pilots include a dedicated TPMS button on the left dash, while others require calibration through the vehicle’s settings menu. Inflate tires to the recommended pressures, perform the appropriate reset (button or calibration), and drive at a steady speed to complete the sensor relearn. Always check your owner’s manual for the exact steps for your car.