The PCV valve on a 2013 Honda CR-V is located on the engine’s valve cover, typically on the passenger side toward the rear, with a short vacuum hose running to the intake manifold.
In more detail, the 2013 CR-V uses a 2.4-liter four-cylinder engine. The PCV valve is a small cylindrical component seated in a valve-cover grommet. A hose from the PCV valve runs to the intake manifold or throttle body area. If you follow the valve cover from the spark plugs toward the back of the engine, you should encounter the PCV valve and its hose along the edge of the valve cover.
Where to Look on the Engine
Use this guide to locate the PCV valve on the 2013 CR-V and confirm it’s connected correctly. The following placements apply to the 2.4L engine in most trims.
- On the valve cover, typically on the passenger side (right side when facing the car) toward the rear of the engine.
- A small cylindrical PCV valve seated in a valve-cover grommet, with a short vacuum hose connected to the intake manifold or throttle body area.
- The hose may run toward the throttle body and connect to a port on or near the intake manifold; sometimes the hose attaches to a metal pipe near the intake.
- Some models route the PCV hose to the air intake duct or the throttle body region as part of the PCV system.
Concluding: If you can’t locate it, check behind the engine near the firewall on the passenger side and verify the hose connection to the intake manifold is intact. If the PCV valve or hose is clogged or cracked, replace the valve and hose as a single kit.
How to Inspect and Replace (Brief)
When inspecting, look for cracks in the hose, a loose hose clamp, or a PCV valve that rattles when shaken. Replacement kits are inexpensive and readily available at auto parts stores. Replace with the engine cold and follow the vehicle’s service manual torque specs if removing the valve cover.
To replace, gently pull the hose off, unscrew the PCV valve from its grommet, install a new valve, reattach the hose, and ensure the hose is seated and the clamps are secure.
Summary
The PCV valve on a 2013 Honda CR-V is located on the valve cover on the passenger side toward the rear of the engine, with a short hose running to the intake manifold. Locating it is straightforward by following the hose from the throttle body area to the valve cover, then inspecting or replacing as needed.
Regular inspection of the PCV valve and hose helps maintain engine efficiency and prevent oil leaks or rough idling. If in doubt, consult a repair manual or a certified technician for your exact trim level and engine code.