The oil filter on a Dodge Journey is a spin‑on canister mounted to the engine block, but the exact location depends on the engine installed in your vehicle. In most models you’ll find it on the engine side near the front or underside, and access can require removing a shield or working from underneath. Check your specific year and engine to be sure.
Engine variants and likely locations
2.4-liter World I4 engine
On the 2.4L World inline-four engine, the oil filter is typically mounted on the engine block toward the front passenger side. It is a relatively compact canister that can be accessed from the wheel well area or from above after removing any protective shields. A flashlight helps you spot the filter, which is the cylindrical canister with threading on the end.
Note: Access can vary by year and shielding configuration, so confirm with the service manual if you don’t immediately see it.
3.5-liter V6 engine
For the 3.5L V6 option used in some Journeys, the oil filter is usually located near the front underside of the engine, close to the oil pan. You may need to get underneath the vehicle or remove a splash shield to gain access. It is again a spin‑on type, and a filter wrench will typically be required to loosen it.
Always verify with your specific year and VIN, since factory shielding and engine layout can change access points.
How to locate it if you’re unsure
If you cannot visually confirm the oil filter location from the guidance above, use these practical steps to identify it safely and accurately:
- Park on a level surface, engine off and cool. Apply the parking brake.
- Open the hood and inspect the engine block for a cylindrical metal canister with threading on one end; this is the oil filter.
- If you can’t see it from the top, slide under the vehicle (with proper supports) after removing any splash shield; the filter is commonly found near the oil pan or along the side of the engine block.
- Consult the owner’s manual or a factory service diagram for your exact year and engine code to confirm the orientation and access path.
These steps should help you locate and identify the Dodge Journey oil filter for maintenance. If you’re not comfortable working under the car, consider professional service or a trusted repair guide.
Summary
The Dodge Journey’s oil filter is a spin‑on canister mounted to the engine block, with location varying by engine type. For the 2.4L World engine, look on the front passenger side of the engine block; for the 3.5L V6, check the front underside near the oil pan (often behind a splash shield). Always verify with the specific year and engine code in your manual or a service diagram to ensure accurate access.
Where is the engine oil filter located?
The oil filter is usually located beside the oil pan or under the hood of your vehicle near the engine. Place the collection pan under the filter. You can use a filter wrench to help remove.
Can you make a Dodge Journey faster?
Enhance the performance of your Dodge Journey with our cutting-edge chiptuning solutions. With GÄN Tuning, we specialize in increasing your car's power and efficiency. Our modules offer up to 30% more horsepower and a 15% reduction in fuel consumption, ensuring an exhilarating yet economical drive.
Where is the oil filter on a Dodge?
This making sure you have an oil collector on. Hand. Let the oil run out for about 10. Minutes.
Where's the oil filter on a Dodge Journey?
So due to this. It's an oil filter on the top. Um we're just going to go ahead and replace the oil filter now then we'll drain the oil.