The oil filter on the 2013 Accord Sport (2.4L four-cylinder) sits inside a cartridge in an oil filter housing on the engine’s passenger side, near the firewall and above the oil pan. Access is typically gained from above once you remove the engine cover, though some service may require lowering the front of the engine or removing a shield to get a clear view.
Below you’ll find a practical guide to locating the filter, what you’re looking for, and basic steps if you’re planning a DIY oil change. Note that the exact path may vary slightly by model year and trim, but the cartridge-in-housing setup is the standard for the 2.4L Accord Sport.
Location and access
What you’ll see and where to look
To help you locate it quickly, consider these cues:
- Engine bay position: the filter housing is on the engine’s passenger side, near the firewall, and just above the oil pan.
- Filter housing: you’ll find a cylindrical housing with a removable cap or a square/round cap that accepts a socket or tool to loosen.
- Visibility: after removing the engine cover (if equipped), the housing is typically visible without major disassembly; in some cases you may need to peek from underneath with the splash shield removed.
In short, the oil filter for the 2013 Accord Sport is located in a cartridge-style housing on the passenger side of the engine, behind the exhaust area and above the oil pan.
Replacement steps (cartridge-type filter)
Before attempting any replacement, prepare the area and ensure you have the correct parts. The following steps outline a typical cartridge-filter change for this engine.
To help you follow these steps, here is a concise sequence you can refer to during the process:
- Park on a level surface, engage the parking brake, and disconnect the negative battery terminal if you will be working near electrical components.
- Drain the engine oil if you are performing a full oil change and remove the skid plate or splash shield if required to gain access to the filter housing.
- Remove the engine cover (if present) to expose the top of the engine and locate the oil filter housing on the passenger side near the firewall.
- Loosen and remove the housing cap to access the cartridge filter inside. Carefully pull out the old cartridge and inspect the O-ring seal; replace the O-ring if it is worn.
- Install a new cartridge filter into the housing and reinstall the housing cap securely. Clean any spilled oil from the housing area.
- Reassemble any components you removed (engine cover, shield, etc.). Refill the engine with the manufacturer-recommended oil and check the level with the dipstick.
- Start the engine and listen for leaks around the filter housing; shut off the engine and recheck the oil level after a brief idle if needed.
These steps provide a practical framework for locating and replacing the cartridge filter on the 2013 Accord Sport. Always refer to the vehicle’s service manual for the exact tool sizes and torque specifications specific to your car.
Summary
The 2013 Honda Accord Sport’s oil filter is a cartridge-style filter housed on the engine’s passenger side, near the firewall, just above the oil pan. Access is usually from the top after removing the engine cover, with possible need to clear or remove a splash shield. When replacing, follow standard oil-change precautions and replace the filter cartridge and its seal, then refill and verify oil levels.