On a 2012 Honda Accord, the oil filter is mounted on the engine block toward the front on the passenger side and is accessible from underneath the vehicle when you raise it or remove the lower splash shield.
In 2012, the Accord offered two engines: a 2.4-liter four-cylinder and a 3.5-liter V6. The oil filter location is similar in principle—attached to the engine block near the oil pan—but the exact mounting point differs by engine type. The following guide explains where to look for each configuration and how to access it for routine oil changes.
Two engine options and their filter placements
To locate the filter, start at the bottom of the engine bay and inspect the area around the oil pan on the passenger side. The exact appearance may vary slightly between trims, but the filter sits near the front half of the engine block and is usually reachable from underneath once the undercar shield is removed.
2.4L four-cylinder (K-series) engine
The oil filter on the 2.4L four-cylinder is mounted on the passenger side of the engine block, toward the front, just above the oil pan. Most models use a spin-on oil filter that is accessible from beneath the vehicle after removing the front splash shield.
Useful steps prior to locating and replacing the filter:
- Park on level ground and engage the parking brake. If needed, raise the front of the car and secure with jack stands.
- Remove the front engine undertray or splash shield to expose the lower front area of the engine.
- Look for a cylindrical canister with a threaded cap protruding from the side of the engine block on the passenger side.
When finished, ensure you have a proper drain pan in place and dispose of used oil and filter according to local regulations.
3.5L V6 engine
For the 3.5L V6, the oil filter is located on the front side of the engine block as well, but its exact orientation can vary slightly; it is typically on the front-right (passenger) side of the engine and may be a spin-on filter or filter cartridge housed in a low-profile canister that is accessible from beneath the vehicle.
Preparation steps for the V6 variant:
- Follow the same safety steps as for the 4-cylinder to access the underside.
- Inspect the area around the filter for the location markers or stamped part numbers that identify the filter housing.
- Replace with the correct filter type for the V6 engine as listed in the owner's manual or parts catalog.
After the filter change, refill the engine with the recommended oil and check for leaks with the engine running at idle.
What to know before you work
Always verify your exact engine code (2.4L or 3.5L) and consult the owner’s manual or service manual for the precise filter part number and torque specs. Some models may differ slightly depending on market specifications or trim.
Summary
The oil filter on a 2012 Honda Accord is located on the engine block near the front and on the passenger side, accessible from underneath after removing the front splash shield. The location is generally the same for both the 2.4L four-cylinder and the 3.5L V6, though the exact mounting may vary slightly. Always confirm using your vehicle’s manual and take proper safety precautions when lifting and working under the car.
Where is the engine oil filter located?
The oil filter is usually located beside the oil pan or under the hood of your vehicle near the engine. Place the collection pan under the filter. You can use a filter wrench to help remove.
What is the weakness of the Honda Accord?
This powertrain shines in sport and touring trims providing a balance of power and smoothness that rivals European sedans hybrids with their 2.0 L Atkinson cycle engine and ECVT excel in fuel economy.
Where is the filter in a Honda Accord?
Open the glove. Box on the right side of the glove. Box release the support arm by pushing it back towards the engine push in both rear corners of the glove box and lower the glove.
Where is the oil filter located on a 2012 Honda Accord V6?
And typically you should be able to just remove it by hand but sometimes they get a little bit stuck. So you might need an oil filter wrench. With the help of a wrench loosen it. Up.