The oil filter on a 2015 Honda Accord is a cartridge-style filter housed in a canister mounted to the underside of the engine block, accessible from beneath the vehicle. It is not a traditional spin-on filter.
The exact spot varies a bit by engine, but both the 2.4-liter inline-4 and the 3.5-liter V6 use this canister-style setup mounted in the lower front area of the engine. You’ll typically need to drop or otherwise clear the front undercarriage shield to see it clearly when performing maintenance.
Engine variants and where to look
Below are the general locations for the two engines offered in the 2015 Accord. Use these as a guide, and consult the factory manual for your exact VIN if you want definitive diagrams.
2.4L inline-4 engine (K-series)
Location: The cartridge-style oil filter sits inside a canister attached to the lower front portion of the engine block, on the side facing the front of the car. Access is typically from underneath the vehicle after removing the front splash shield or undertray.
- It is a cartridge-type filter inside a canister, not a spin-on. The cap is usually bolted on and may require a tool to loosen.
- The cartridge inside is replaced during oil changes rather than a whole filter housing.
Concluding: For the 2.4L engine, look for a cylindrical canister mounted low on the front of the engine block; you’ll see it once you remove the undercarriage cover.
3.5L V6 engine (J-series)
Location: The oil filter is also a cartridge inside a canister on the engine block, typically located toward the lower side of the engine near the front, accessible from beneath with the front splash shield removed.
- Again, this is a cartridge inside a canister rather than a spin-on filter.
- Follow standard oil-change procedure to replace the cartridge inside or the entire canister as per the service manual.
Concluding: The 3.5L V6 uses the same cartridge-in-a-canister design located in a similar area under the engine; visibility improves after removing the undertray.
Tools and quick tips
Before you begin, gather supplies and take standard safety steps to avoid spills or injury.
- New oil filter cartridge compatible with your engine
- Correct oil type and quantity per owner’s manual
- Basic hand tools or a strap wrench for the filter housing cap; jack stands or ramps
- Oil drain pan, rags, gloves, and proper disposal method for used oil
- Owner’s manual for torque specs and service interval
Concluding: Replacing the oil filter on a 2015 Accord involves removing and replacing a cartridge inside a canister mounted to the engine block; the process differs from a traditional spin-on filter.
Summary
In short, the oil filter on a 2015 Honda Accord is located in a canister-style housing mounted to the underside of the engine block, accessible from beneath with the front undertray removed. The position is similar for both the 2.4L I4 and the 3.5L V6, though exact placement may vary slightly by engine layout. Always consult the owner’s manual or a service manual for precise diagrams before you start.