The Honda HR-V’s safe lifting points are the reinforced pinch-welds along the rocker panels and the front and rear center crossmembers under the subframes.
Center jack points: front and rear
These are the primary locations used for lifting the HR-V from underneath along the vehicle’s centerline.
- Front center jacking point: located under the front subframe crossmember, near the middle of the vehicle and just behind the bumper. Use a floor jack with a wide pad to contact the reinforced crossmember.
- Rear center jacking point: located under the rear subframe crossmember, near the middle of the vehicle. Position the jack pad on the crossmember to support the rear end.
These central points give you stable, balanced lifting for tasks such as tire changes or basic underbody work.
Side jack points: pinch welds along the rocker panels
When you need to lift the vehicle from the side or place stands under the rocker area, use the pinch welds that run along the bottom of the doors.
- Left side pinch weld: on the rocker panel between the front and rear wheels. Look for a reinforced area or a small indentation indicating the jacking point.
- Right side pinch weld: same location on the opposite side of the vehicle.
- Important tip: ensure the jack pad sits on the solid metal pinch weld, not on plastic underbody panels or trim pieces.
Side lifting is convenient for tire changes on level ground or when you want to set stands at the side jacking points after lifting with a center jack.
Safe lifting procedure
Follow these steps to lift the HR-V safely using the appropriate jack points.
- Park on level ground, engage the parking brake, and place wheel chocks on the opposite side.
- Position the floor jack under the chosen point (front center crossmember, rear center crossmember, or a pinch weld).
- Raise slowly until the jack pad contacts the point firmly and sits flat on metal.
- Place jack stands under the recommended support points. Do not rely on the jack alone to hold the vehicle.
- Lower the vehicle slowly onto the stands and remove the floor jack once the vehicle is securely supported.
Always follow the manufacturer’s instructions and use proper equipment to prevent injury or damage.
Important cautions
To prevent damage or injury, avoid these common mistakes when lifting the HR-V.
- Avoid jacking on plastic trim, underbody shields, exhaust components, or fuel-system areas.
- Do not use the bumper or other non-reinforced surfaces as jack points.
- Never work under the vehicle supported only by a jack; use jack stands at all times.
For the most accurate guidance, verify the exact jacking points in your specific HR-V’s owner’s manual, since configurations can vary by year and trim.
Summary
In the Honda HR-V, lift primarily from the front and rear center crossmembers under the subframes, and use the reinforced pinch welds along the rocker panels for side lifting. Always use a proper floor jack with a wide pad, and support the vehicle with jack stands. Check your year’s owner’s manual to confirm the precise locations and any model-specific notes.