The cabin air filter in most Honda Fits sits behind the glove box on the passenger side, and you access it by opening or dropping the glove box and removing a small filter cover.
In more detail, on many Fit models (including older 2007–2013 and later 2014–2020 versions), the filter is housed in a rectangular compartment behind the glove box. Access typically requires lowering the glove box by squeezing its sides or disconnecting a damper, then removing the cover to reach the filter. While exact clips or screws can vary by year, the underlying location remains consistent.
Location and access
The following steps describe how to locate and open access to the cabin filter in a typical Honda Fit.
- Open the glove box and remove any contents.
- Gently squeeze the sides of the glove box inward (or unclip the glove box damper) so the box drops down or rests lower, exposing the area behind it.
- Look for a rectangular plastic housing with a filter cover, usually on the passenger side behind the glove box. Some models use a small locking tab; others require removing a couple of screws to remove the cover.
After identifying the housing, you can proceed to remove and inspect the filter.
Replacing the cabin air filter
Follow these steps to replace the filter in a typical Honda Fit. If your model year differs, refer to the owner's manual for any small variations.
- With the glove box lowered, locate the cabin air filter housing behind the opening.
- Unclip or unscrew the filter cover, then slide the old filter straight out, noting the orientation (arrow on the filter should point in the direction of airflow, usually toward the passenger side).
- Insert the new filter in the same orientation, making sure it sits evenly in the housing.
- Reattach the filter cover, lift the glove box back into place, and ensure it latches securely.
After replacement, run the climate control on fresh or recirculated air to confirm proper airflow and listen for any unusual noises that might indicate improper seating.
Summary
In short, the Honda Fit cabin air filter is located behind the glove box on the passenger side. Access involves lowering the glove box to reveal a rectangular housing with the filter. Replacing the filter is straightforward with basic tools and requires paying attention to filter orientation.
Notes for different model years: Older Fits (roughly 2007–2013) follow the same general layout, while later models (2014–2020) keep the same behind-the-glove-box arrangement, though the exact damper or clip mechanism may vary. Always consult the owner's manual for year-specific details.