The cabin air filter in a 2018 Jeep Renegade sits behind the glove box on the passenger side. To replace it, drop the glove box and access the rectangular filter housing from there.
Location and access
In the 2018 Renegade, the cabin filter is housed inside a small rectangular compartment behind the glove box on the passenger side. Access is achieved by lowering the glove box and removing the filter housing cover.
Replacing the filter: a step-by-step guide
To guide you through the replacement, follow these steps. You’ll need a new cabin air filter and a flashlight for visibility.
- Open the glove box and remove its contents, then gently press in the sides of the box so it drops down and gives you access to the area behind it.
- Locate the filter housing on the right side of the glove box opening and release its cover (there may be a small tab or clip).
- Remove the old filter from the housing and note the orientation of the arrows on the filter.
- Insert the new filter with the arrows pointing toward the blower housing (in the direction of airflow into the cabin).
- Reattach the filter housing cover, lift the glove box back into place, and re-engage any dampers or stops that were moved.
- Run the HVAC system on a low setting to verify proper airflow and ensure the fit is secure.
Careful alignment of the filter and proper seating in the housing help prevent issues such as air leaks or rattle noises. If you encounter resistance or can't locate the housing, consult the vehicle’s manual or a dealer service department.
Summary
The cabin filter in a 2018 Jeep Renegade is located behind the glove box on the passenger side. Replacement involves dropping the glove box, removing the filter cover, swapping in a new filter with proper orientation, and reassembling. Regular replacement keeps cabin air clean and HVAC performance optimal.