The cabin air filter on a 2019 Mitsubishi Outlander Sport sits behind the glove box on the passenger side and is accessible by lowering the glove box and removing a small cover to reveal the filter.
Location and access
In the 2019 Outlander Sport, the cabin air filter is tucked away behind a rectangular access panel at the back of the glove box area on the passenger side. Access is gained by lowering the glove box and removing the cover that hides the filter housing. Depending on trim and regional market, the exact panel may vary slightly, but the general placement remains the same.
What you might see
With the glove box lowered, look for a small rectangular cover labeled for the cabin air filter or a removable panel that exposes the filter housing. The filter itself slides in and out within a plastic frame, and it’s usually held in place by the cover or a couple of clips.
Note: Some trims use a glove box damper or a soft-stop mechanism. If you don’t immediately see a filter cover, consult the owner's manual for your specific trim to confirm the exact access point.
Replacement steps
Here are the steps you’ll follow to replace the cabin air filter. Make sure you have a replacement filter that matches the 2019 Outlander Sport and that you have adequate lighting and a clean workspace inside the vehicle.
- Open the glove box and remove its contents to create space for access.
- Gently squeeze the sides of the glove box or release its dampers to allow the box to drop downward and expose the back panel.
- Locate the rectangular cabin air filter cover at the back of the glove box area and remove it by pulling the tabs or unclipping it.
- Slide the old filter out from its housing and note the orientation of the arrows indicating airflow.
- Insert the new filter with the arrows pointing in the direction of airflow (toward the HVAC unit). Ensure it sits flush in the housing.
- Replace the filter cover, lift the glove box back into place, and make sure it latches securely.
After replacement, test the HVAC system to confirm air is flowing properly through the vents and that there are no unusual noises or resistance.
Tips and variations
Variations by trim or market can shift exact panel names or access methods, but the general approach remains consistent: access behind the glove box, remove the cover, replace the filter, and reseal. If you’re unsure, referring to the owner's manual for your specific trim or consulting a dealership can help ensure you’re following the correct procedure.
Summary
For a 2019 Mitsubishi Outlander Sport, the cabin air filter is located behind the passenger-side glove box. Access is gained by lowering the glove box and removing a small cover to reveal the filter housing. Replace the old filter with a new one in the correct orientation, reattach the cover, and restore the glove box. This quick maintenance helps maintain cabin air quality and HVAC performance.