The cabin air filter in most Chrysler Town & Country minivans is located behind the glove box inside the dash. Access is typically gained by lowering the glove box and opening a small rectangular panel that hides the filter housing.
Location and access
To begin, you’ll want to expose the filter housing behind the glove box. The steps below outline a typical access path used on common Town & Country years; variations may exist by year or trim, so consult your manual if needed.
- Open the glove box and gently release its stops or hinges so the box can drop down further.
- Look for a rectangular access door or panel on the side or back of the glove box area labeled “Cabin Air Filter.”
- Open that panel to reveal the filter housing and the old filter.
- Remove the old filter, inspecting the housing for debris or leaves and wiping it clean if necessary.
- Prepare to install a new filter, ensuring the orientation (arrow) matches the direction of airflow.
Note: Some model years may require removing a trim piece or a couple of screws to drop the glove box further or to access a different panel. If the filter isn’t immediately visible behind the glove box, check the passenger-side dash area or the owner’s manual for your exact year.
Replacement steps
Follow these steps to replace the cabin air filter correctly and ensure optimal airflow and filtration.
- Turn off the engine and set the HVAC controls to a neutral position before working on the filter.
- Open the glove box and release its stops so it can swing down fully.
- Open the access panel behind the glove box to access the filter housing.
- Remove the old filter by sliding it straight out of the housing.
- Insert the new filter with the arrows pointing toward the rear of the vehicle, reseal the housing, and reassemble the glove box.
After installing the new filter, run the HVAC system on a few minutes to confirm normal airflow and listen for any unusual sounds or odors.
Variations by year and model
While the behind-the-glove-box location is common, some Town & Country models from different years may place the filter differently or omit a cabin air filter entirely. If you drive an older model (early- to mid-2000s) or a special edition, verify with the owner’s manual or a trusted repair guide for your exact year and trim. Note that the Town & Country name has been phased out in favor of the Chrysler Pacifica in later years, and the Pacifica can have its own slightly different access path.
Maintenance tips and warning signs
Plan to inspect and replace the cabin air filter on a regular schedule, typically every 12,000 miles (19,000 km) or 12 months, whichever comes first, or sooner if you notice reduced airflow, musty odors, or increased pollen exposure.
Summary
In a Town & Country minivan, the cabin air filter is typically located behind the glove box inside the dash. Access is usually gained by lowering the glove box and opening an adjacent panel to reach the filter housing. Replacement steps involve removing the old filter and inserting a new one with the correct airflow direction, then reassembling. Because model years and trims vary, consult your owner’s manual for the exact location and steps for your vehicle, and replace the filter on schedule to maintain good cabin air quality and HVAC performance.