The engine air filter on a 2010 Honda CR-V sits inside a rectangular black plastic air‑box in the engine bay, on the passenger side toward the front of the vehicle. It is accessible from above and can be replaced with basic tools.
The air box is part of the intake path feeding the engine and is secured with clips or small screws. Replacing the filter is a routine maintenance task that takes only a few minutes with the right parts and a little patience.
Where to look in the engine bay
In the 2010 CR-V, the engine air filter housing is the rectangular black plastic box on the passenger side of the engine bay. It sits near the front of the engine compartment and is connected to a large intake hose that leads toward the throttle body. The lid is held on by a few clips or small screws.
Tools and supplies you'll need to perform a standard engine air filter replacement.
- Replacement engine air filter compatible with the 2.4L engine in the 2010 CR-V
- Basic hand tools (a screwdriver or a socket set may be needed for screws, if your model uses them)
- Clean rag or paper towels
- Flashlight or good lighting (optional but helpful)
With the right parts and a little care, replacing the air filter is usually quick—often 5 to 10 minutes for a typical replacement.
Step-by-step replacement: access, swap, and reseal
Follow these steps to access the air filter box, replace the old filter, and reseat the housing securely.
- Park on a level surface, switch off the engine, and open the hood. Locate the air filter housing on the passenger side of the engine bay.
- Release the lid: unclip the retaining clips or remove the screws that secure the air box lid, then lift the lid to expose the filter inside.
- Remove the old filter, noting its orientation. Check the inside of the air box for debris or moisture and wipe clean if needed.
- Install the new filter with the correct orientation. The filter typically has an airflow arrow that should point toward the engine/throttle body.
- Re-seat the lid and re-secure the clips or screws. Make sure the intake hose and any clamps are properly seated to prevent air leaks.
- Close the hood and start the engine to ensure there are no abnormal sounds or air leaks.
Installing the new filter correctly restores proper airflow and engine performance. For best results, follow your owner's manual’s recommended replacement interval or replace sooner in dusty or harsh driving conditions.
Cabin air filter: not the same as the engine filter
The cabin air filter in the 2010 CR-V is located behind the glove box, not in the engine bay. If you’re also replacing the cabin filter, you’ll need to access the glove box and remove the filter cover as directed in the owner's manual.
Summary
For a 2010 Honda CR-V, the engine air filter lives in the passenger-side engine bay inside a rectangular air‑box toward the front of the vehicle. Replacing it involves opening the lid, swapping in a new filter in the correct orientation, and reseating the box. Always refer to the owner's manual for your exact replacement interval and any model‑specific fastener details, and consider replacing the cabin filter separately if needed.
How to tell if air intake is clogged?
Which can lead to a number of performance. Related issues as it will throw off your airto fuel ratios the ultimate result is decreased. Performance rough idling misfires.
Where is the air filter located on a 2010 Honda CRV?
Side behind the glove. Box first open the glove box on the side of the glove box is a damper arm release the damper arm from the glove. Box.
Which CRV is the fastest?
When it comes to speed and acceleration, the Honda CR-V stands out as the fastest SUV in Honda's lineup, particularly the Hybrid Sport Touring model. This version achieves a remarkable 0 to 60 mph time of approximately 7.7 seconds, which is impressive among compact SUVs.
Which engine oil is best for a Honda CR-V?
To get the best results, your Honda CR-V oil type needs synthetic 0w-20 or 0w-30 rated oil. Synthetic oil is the top choice because it's highly durable and can handle high temperatures.